Care Quip AA0110 User manual
AA0110 Bathboard
USER MANUAL
Care Quip Pty Ltd
5 Millennium Court Silverwater NSW 2128
www.carequip.com.au
| AA0110 Bathboard User Manual V2.2
2
Welcome
Congratulations on the purchase of this Care Quip Bathboard.
This user manual provides a guide on usage and tips to ensure that you can operate your bathboard to achieve the best
results.
To ensure you are satisfied with the level of service, required replacement parts and accessories or have any questions
concerning the use or maintenance, please contact you authorised Care Quip dealer. Where there is no authorised
dealer in your area please contact:
Care Quip
5 Millennium Court Silverwater NSW 2128
02 9714 1111 info@carequip.com.au
SYMBOLS
!
DANGER A message regarding possible risk of a serious accident.
!
WARNING A message regarding possible risk of injury.
!
CAUTION A message regarding possible technical damage.
NOTE: Important information about the product.
!
The bathboard can be slippery when wet – use with caution
!This bathboard is designed as a temporary seating aid only. Do not use the board as a step. Do not tip or put an
oset load onto the board or injury may occur
!
Do not install the bathboard if there is a shower door track on the side of the bath
!The bathboard is not recommended for use on free standing baths, or baths with no side wall
!
Supervision or assistance is recommended for users with limited mobility when using the bathboard
!Before use, ensure the side of the bath is wide enough for the bathboard to rest safely on. When
installed the bathboard should not exceed the outside wall of the bath by more than 20mm
!When using a bathboard, it is recommended that the user be able to sit with good balance; to lift
their legs over the edge of the bath; and to bend at the hips
!The bathboard is manufactured from lightweight, slip resistant moulded plastic with adjustable
handgrip for added security. Fits majority of baths.
!
Some minor assembly is required
| AA0110 Bathboard User Manual V2.2 3
Assembly
Insert the eight rubber pads into the slots underneath the
board, with rounded edges facing out.
To attach the feet, position foot with rubber pads facing
outwards and insert screw down through the positioning
channel. Tighten loosely enough to allow the foot to
slide freely for final positioning when in bath. Repeat for
remaining three feet.
To attach the safety handgrip, position the handle over
the top of the board and secure with two plastic screws.
Tighten firmly to ensure the handgrip is securely attached.
Positioning the board
The side of the bathboard with the handgrip must be
closest to the wall. Ensure the bathboard is positioned as
close to the side wall as possible.
Adjust the feet to fit snugly inside the bathtub. Once in
place, tighten the screw to secure the feet firmly in place.
The angle of the rubber pads may be adjusted to suit the
angle of the bathtub walls.
Check that the bathboard feels secure and cannot
be easily moved when pulled forwards, backwards or
sideways.
Before use, ensure the bathboard is squarely and
securely positioned over the bath. Using a slip proof bath
mat will increase safety when using the bathboard.
IMPORTANT: Do not use your bahtboard until this manual has been read and understood
Hand Grip
Wall
Do not lean this device over. Place the handle on the wall side of the bath
Max User Weight 110kg
Do not exceed temperature limit 3O- 70OC
Wash with warm water and mild soap after each use and dry throughly
Do not use safety handle to assist in standing. Forced weight on one handle may cause bathboard to
become unstable.
Fit footrest within the bathtub surface slope for safe use
!
!
!
!
!
!
Table of contents
