
www.careco.co.uk CareCo, Hubert Road, Brentwood, Essex, CM14 4JE
Once you have installed the shower seat check your installation and the movement of the shower seat by raising the seat from
the down position to the up position.
• Check that there are no obstructions
• Check that the movement of the seat is smooth and unhindered
• Check that the seat legs (if applicable) are sitting evenly on the floor
Testing the Shower Seat
To raise your seat, simply lift the front of the seat and the legs will automatically fold inwards towards the wall. Reverse the
action to lower.
Raising and Lowering Shower Seat
If required, your shower seat can be folded up when not in use. The seat is held in position by friction only. Once you have
installed the seat, check that there is sufficient friction to keep the seat in the upright position when required. If the seat starts
to descend, then you will need to tighten the bolts either side of the seat hinges. This operation should be sufficient to maintain
the seat in the closed position. Additionally, it will be necessary for the bolts to be tightened periodically, if the seat starts to
open on its own accord.
Folding Action
Your shower seat may have special threaded leg adjustment as opposed to the standard extension leg. To adjust the height of
your seat, carefully open the stainless steel M10 locking nut and undo the threaded stem to the desired height. On no account
exceed a finished height of 470 mm measured from the top of the seat to the bottom of the black circular foot, as this may
compromise the safety of the user. Once you have reached the desired height, lock the stem in place by tightening the lock nut
against the black indented bush. NB. Occasionally the extension stems may be slightly angled inwards to the frame. This is not
a fault and will not impair the function or safety of the product, provided that you tighten off the lock nut as required.
Threaded Leg Adjustment
Usage and Maintenance Instructions
Soho Deluxe Folding Shower Seat - BA06044
If you reissue or are about to reissue this product, please thoroughly check all components for their safety. This includes:
• PAT test for electrical items
• Tightness of all nuts/bolts/castors
• Other screw in/bolt in/push in components.
• Also check all upholstery for security, splits, etc.
If in any doubt, please do not issue or use, but immediately contact your supplier for service support. When reissuing, a risk
assessment may be required as to the suitability of the chair for a particular user.
Reissue
Important Infomation
Your CareCo branded product is under warranty to be free from defects in material and workmanship for one year from date of
receipt. This warranty expresses our confidence in the workmanship and materials used for our products.
In the event of a defect covered by this warranty, CareCo will, at our discretion, replace the product or supply parts to remedy.
This warranty does not cover device failure due to owner misuse or negligence, or due to normal wear and tear. The warranty
does not extend to non-durable parts, such as rubber accessories, castors and grips, which are subject to normal wear and tear
and require periodic replacement. If you have any queries please contact CareCo.