Carymart S1ps1-dc06-ant2 User manual

SHENZHEN GUIYUAN INDUSTRY DEVELOPMENT CO.,LTD

Http://www.caymart.com E-Mail: sale@carymart.com

1 CH 2000m RF Wireless Remote Control Firework Ignitor System

Package Include:

1 x Receiver: S1PS1-DC06-ANT2 (1 Channel / DC6V)

1 x Transmitter: CB-1L

1 x User manual

Feature:

Wireless control, easy to install

It can ignite various kinds of electric fireworks directly, or ordinary fireworks through fireworks electric igniter, which reduces accidents like skin burn

and accidental explosions.

One ignitor can light several fireworks at the same time.

One transmitter can control many ignitors simultaneously.

The ignitor can be remotely controlled from any place within a reliable distance; wireless signal pass through walls, floors and doors.

More reliable than fixed code: The transmitter use EV1527 Learning code, which is up to 1 million codes, reducing code collision and unauthorized

code scanning possibilities.

Transmitting Frequency: 433MHz

Working distance of transmitter and receiver with external extend antenna: 2000M /6000ft (theoretically)

Receiver:

Model No.: S1PS1-DC06-ANT2

Channel: 1 CH

Power Supply (Operating Voltage): 4 x1.5V AA batteries (excluded)

Power Output: DC6V

Case size: 105mm x 75mm x 20mm

Static Current: ≤5mA

External Extend Antenna:

Frequency Range: 300~450MHz

Impedance: 50Ω

Antenna Length: 15cm

Cable Length: 150cm

Weight: 35g

Anti-interference, waterproof, shielded wire set inside

Magnetic stand design for easy to install

Transmitter:

Model No.: CB-1L

Button: 1 button

Remote Control Distance: 1000m / 3000ft (theoretically)

Encode: EV1527 Learning code (up to 1 million codes, reducing code collision)

Unit Size: 135mm x 42mm x 25mm

Power Supply: 1 x 6F22-9V battery (included, can be used for 12 months)

Usage:

Remote Controller Learning:

1. Put 4 pcs AA batteries to the receiver battery box and switch on the power, using a small stick to press and hold the button in the little hole on the

back side of the receiver box for 3 seconds. Then the power LED light and signal light will flash. The receiver enters into status of LEARNING.

2. Press the button on the transmitter, the signal light will be off and the power LED light flashes 2 times, then the signal light is on again. It means

learning is successful. (We have set the receiver to learn the transmitter, you can use them directly.)

Operation:

1. Test the firework ignitor system: switch on the receiver box, press the button on the transmitter, signal light will be off and the power LED light