CasaOne Ancha Vista Mid-Century Lounge Chair User manual

Label Picture Description QTY
A Chair 1
B Chair Base 1
Label Picture Description QTY
①
Long Bolt
(M8*70mm)
5
②Allen Key 1
Picture
Caution : You must read this before you proceed
Chair

③Washer 5
④Spring Washer 5
Before Beginning
Assembly:
Overview
This Chair has multiple parts and may require up to 30 minutes to assemble.
To give you an overview of the chair parts, the above picture is to help you
put the various parts into perspective. Please read through the instructions
below to familiarise yourself with the parts and steps before assembly.
FRONT FACING
Chair Base (B)
Chair
（
A )

Step 1
Step 2
Step 3
With assistance from your adult partners,Turn the Chair(A) face down on a clean, non-
marring surface as shown in picture.
Attach Chair Base(B) onto the bottom of the Chair(A) using Bolts(①) 、Spring
Washer(④)、Washer(③) with Allen Key(②).
Note:The 2 shorter legs and 2 longer legs should be at the right direction as pictured
above.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move towards the next one.
This could cause the other Bolts and mounting points to be out of alignment.
Ensure that all the Bolts are not fully driven in.
Stand the Chair right side up and ensure it is stable.
Place the Chair on a level Surface to check if it wobbles.
If it wobbles, it's very likely that the Chair Base is not fixed perfectly. Please remove the
Chair Base Bolts and make a little adjustment. Then reattach.
If no wobbles are found, proceed to tighten all the Bolts.
Your Chair is ready for use.
Caution: This Chair can only be used on a flat, level surface.
2 longer legs
2 shorter legs
②
①
④
③
①
②
③
④
A
B