To comply with FCC’s RF exposure limits for general population / uncontrolled exposure,
the antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
This Device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
The VN210 RF Module has been certified per FCC Part 15 rules for integration into
products without further testing or certification. To fulfill the FCC certification
requirements the OEM of the VN210 RF Module must ensure that the information
provided on the VN210 RF Module label is placed on the outside of the final product.
The VN210 RF Module is labeled with its own FCC ID Number. If the FCC ID is not visible
when the module is installed inside another device, then the outside of the device into
which the module is installed must also display a label referring to the enclosed module.
This exterior label can use wording such as the following:
“Contains Transmitter Module FCC ID: 2AKZ5-CDSVN210ISA” or
“Contains FCC ID: 2AKZ5-CDSVN210ISA”
Only the approved antennas, which have been certified with this module should be
used. The approved antennas are:
ANT-2.4-CW-RCT-RP Linx Technologies (2.2dBi)
ANT-N-5 Mini-Box (5.5 dBi)
FS1-F9915KB Yokogawa (2.0 dBi)
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
