Celestron SkyScout Scope 90 User manual

Use the three tightening screws located at the bottom
of each leg to secure the extended legs
in place.
To set up the tripod, spread the legs outward until
they are fully extended. Extend each of the three
tripod legs as far as they will go.
Quick Set-up Guide
123
All three legs should be the same length to provide a
level platform for the telescope.
4
7
Here is how the fully assembled tripod and mount
should appear.
5
Properly assembled, the accessory tray should appear
as pictured above.
6
Next slide telescope tube into the mount. Be sure to
back out fastening screws to allow enough clearance
for the dovetail.
8
Center dovetail in the mount and tighten fastening
screw. For added security tighten the angled lock
down screw next to the fastening screw.
9
Quick set-up guide for:
Model #21068 – SkyScout Scope 90
Your SkyScout Scope 90 includes: optical tube w/
attached SkyScout mounting bracket, pre-assembled
tripod with center leg brace and altazimuth mount
attached; two eyepieces; erect image diagonal,
finderscope and bracket, accessory tray, owner's
manual, and The Sky™ CD Software. SkyScout not
included.
To attach the accessory tray, line up the three tabs
and turn clockwise until tray tabs lock into place with
the tripod’s center leg brace.
Questions or Problems with Set-up?
CONTACT: Celestron Technical Support:
310.803.5955
www.celestron.com
Dovetail
Mount
Fastening
screws

Loosen the set screw on the focuser. Remove the
plastic cap covering the end of the focuser.
11
Insert the diagonal into the focuser and tighten the
set screw.
12
13
Slide the finderscope into the dovetail bracket built-in
to the focuser. Secure finderscope with locking screw.
14
Hold the SkyScout with the larger targeting window
towards the front end of the telescope. Align the holes
at the bottom of the SkyScout with the alignment pins
on the bracket. Place the holes over the pins and
press the SkyScout down until it is firmly seated on
the bracket.
15
Use the adjustment knobs on the bracket to align the
SkyScout with the telescope's eyepiece. See
instruction manual for complete alignment procedure
16
Select an object to locate from the SkyScout's
database.
10
Insert the chrome barrel of the 40mm eyepiece into
the diagonal and tighten the set screw.
For detailed usage information please consult
your owner’s manual.
Quick Set-up Guide [cont]
WARNING: Never attempt to view the sun through any telescope
without proper filtering!
19
Look inside the 40mm eyepiece and center the object.
Rotate the pan handle to lock the telescope in place.
17
Rotate the telescope's pan handle counterclockwise
and move the telescope in the direction indicated by
the red targeting arrows.
18
Slowly move the telescope until all the targeting
arrows are illuminated.