Ceotis COB-BEL-135-VG User manual

IP65
Installation of LED High Bay
135W
Size
300x270mm AC220-240V 50Hz 50
1. Disconnect mains supply before installation or
removing cover.
- THE PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN.
- THE POWER SUPPLY MUST BE TURNED OFF BEFORE INSTALLATION.
- NO WARRANTY WILL BE ACCEPTED IF THIS PRODUCT IS NOT INSTALLED BY A QUALIFIED
ELECTRICIAN.
- THE LIGHT SOURCE CONTAINED IN THIS LUMINAIRE SHALL ONLY BE REPLACED BY THE
MANUFACTURER OR HIS SERVICE AGENT OR A SIMILAR QUALIFIED PERSON
- THE EXTERNAL FLEXIBLE CABLE OR CORD OF THIS LUMINAIRE CANNOT BE REPLACED; IF THE CORD IS
DAMAGED, THE LUMINAIRE SHALL BE DESTROYED.
- DO NOT OPERATE THE PRODUCT WITH A DAMAGED LENS; THE DAMAGED LENS SHOULD BE REPLACED BY
THE SERVICE AGENT.
- THE DRIVER CAN’T BE REPLACED.
- THE TERMINAL IS RATED VOLTAGE IS 300V,RATED CURRENT IS 3A,THE WRING IS NOT LESS THAN 3 X 1.0MM².
- WHEN PRODUCTS ARE INSTALLED IN HIGH WIND ENVIRONMENTS, APPROPRIATE INSTALLATION/FASTENING
METHODS MUST BE APPLIED SO THAT THE PRODUCT MOUNTING POINTS ARE NOT DAMAGED DUE TO
VIBRATION,MOVEMENT OR CORROSION.
- GOOD PRACTICE DOES NOT RECOMMEND CONTINUOUS USE WITHOUT APPROPRIATE SWITCHING CYCLES.
2. Use a screwdriver to fix the reflector to the luminaire with screws.
LED High Bay Installation Guide
COB-BEL-135-VG
RÉF.

CEOTIS ECLAIRAGE
C/O SOITEC
Parc technologique des fontaines Chemin des Franques
38190 Bernin France
Email:[email protected]
TEL: [phone]
5. Reconnect mains supply
5
3
3. Hook the end of the safety chain into the ring on the top of the
luminaire.
4
4.Individually connect the Live wire, Neutral wire and Ground
wire of AC input wire to Brown, Blue and Green-Yellow wire.
All cable teminations must be installed in accordance with the
designed IP rating.
Outer insulation
Inner insulation
40±3 6±2
Brown L
Blue N
Green-Yellow GND