CGS Mobile Command Center User manual

Mobile Command Center
Quick Start Guide
Deploying your Mobile Command Center (MCC): While variaons exist among the available conguraons of the
MCC line, the same basic steps are used to deploy your unit. If variaons are signicant with your conguraon,
you may also have an addendum included with this guide. Please retain all instrucons with your kit to ensure
proper deployment of your system.
Ensure your case locks are in the vercal
‘unlock’ posion, and ip open latches.
Open case. Swing open trays. Note the order in which
they unfold, as they will be folded back in reverse order
when packing kit away.
Connect Power Brick (outlet & cable marked red). Turn on baery
by holding down power buon next to charge indicator, and slide
AC switch next to outlets. LED will indicate red when on. Your router
will power on and begin to boot. Wait unl router has connected to
LTE service (~3-7 min), then connect power to switch (outlet & cable
marked blue). Phones will begin to boot. If desired, the USB power
(outlet & cable marked white) can be connected for case lighng.
Connect antennas to router. Sck antennas connect
to WIFI ports, paddle antennas to LTE ports. Router
models vary, and antennas/ports may be color coded
to aid in placement or an included addendum may be
included with details on your specic router chosen.
Do not overghten antennas.
Connued on reverse…
Contact Support at [e-mail] or 804.238.6111

Mobile Command Center
Quick Start Guide Conued...
Once phones are booted, your system is ready to use! To connect
addional devices to the MCC network, connect WIFI devices using
network info found under the router (viewable through window in
tray from underside), or connect ethernet devices to the switch.
Note that ports 1-4 are POE, 5-8 are passive.
Addional Informaon...
External charging port: To charge your MCC, connect the included
power supply or solar panel to the external port by rst ipping
open the weatherproof cap. Charging is conrmed by baery level
indicator ashing on baery, with ‘FF’ indicang a full charge.
When not in use, keep cap rmly in place to ensure the
weatherproof qualies of the case are maintained.
When closing your MCC, should the lid oer any resistance, please li
slightly on the hinges to remove them from the locking posion. Failing to
do so can damage your hinges if forced! Also, please remove antennas
and unplug power cords before closing case back up.
To extend the handle for easy rolling transport, simply slide the
lever while pulling the handle to extend. To retract back into the
case, simply slide the lever again while pushing the handle back
into the case completely.
Contact Support at [e-mail] or 804.238.6111