Channel Vision 6115 User manual

CHANNEL VISION
Limited Warranty
Channel Vision Technology will repair or replace any defect in material or
workmanship which occurs during normal use of this product with new or rebuilt
parts, free of charge in the USA, for two years from the date of original purchase. This
is a no hassle warranty with no mail in warranty card needed. This warranty does not
cover damages in shipment, failures caused by other products not supplied by
Channel Vision Technology, or failures due to accident, misuse, abuse, or alteration
of the equipment. This warranty is extended only to the original purchaser, and a
purchase receipt, invoice, or other proof of original purchase date will be required
before warranty repairs are provided.
Mail in service can be obtained during the warranty period by calling [phone]
toll free. A Return Authorization number must be obtained in advance and can be
marked on the outside of the shipping carton.
This warranty gives you specific legal rights and you may have other rights (which
vary from state to state). If a problem with this product develops during or after the
warranty period, please contact Channel Vision Technology, your dealer or any
factory-authorized service center.
500-1
3
9 rev B
Specifications:
Image Sensor:
Picture Elements:
Resolution:
S/N Ratio:
Min Illumination:
Electronic Shutter:
Gain Control:
Gamma Characteristic:
Operating Temp:
Sony 1/3” Super HAD
NTSC: 510x492
380 lines
More than 48 dB
0.2 LUX @ F2.0
1/60s - 1/100,000s
Automatic
0.45
-10°C to 50°C (14°F to 122°F)
Specifications subject to change without notice.
Auto White Balance:
Camera Lens:
Sync. System:
Power Requirements:
Power Consumption:
Video Output:
Color Temperature: 2500K-9500K
3.6mm / F2.0
Internal, Negative sync.
12VDC
145 mA
1 Vp-p @ 75 ohms
6115
Small Outdoor Color Dome Camera
8

2
Features:
High quality 1/3” Sony Super HAD CCD sensor
Digital Signal Processor (DSP) chip-set provides image
control
High sensitivity, low smear, high anti-blooming and high
S/N ratio
Automatic Gain Control (AGC) and Auto White Balance
(AWB)
3-Axis mechanism for easy rotation and adjustment
h
h
h
h
h
The is a small outdoor color dome camera. It is perfect
for CCTV applications that require mounting flexibility. Its
small size and unobtrusive design make it perfect for
residential use.
6115
Dome Camera
1. Tilt camera to
desired angle
2. Rotate camera to
desired direction
3. Rotate camera ring
so that the image
appears ri
g
ht side up
Adjusting the 3-Axis Mount
Power Supply
Hex Wrench
Screws & Wall Anchors
Top
Tilt
Top
Top
Rotate
Rotate
3
Model
611
5
3. Adjust camera
4. Attach dome
(see page 2)
Finished
1. Connect wiring
2. Mount base
Installation:
Use the hex wrench to remove the dome cover from the
base.
Drill a hole in the wall or ceiling for wiring (see diagram).
If necessary, attach the camera’s video output to a coax
extension that is long enough to reach your monitor or
video distribution equipment.
If necessary, cut the connector off of the end of the power
supply and splice in an extension using crimp-on
connectors.
Mount the base with the provided screws.
Move the camera body to adjust the view.
Attach the dome and secure it with the hex wrench.
h
h
h
h
h
h
h
2-Conductor power
supply extension
(not included)
Crimp-on splice
connectors
(not included)
To Monitor
or
Video distribution
Power supply
(included)
Coax extension
(not included)
BNC connector