CHIEF PSM-2394 User manual

INSTALLATION INSTRUCTIONS
CHIEF MANUFACTURING INC. 8805-000095 REV C
1-800-582-6480 952-894-6280 FAX [phone] Chief Manufacturing
8401 EAGLE CREEK PARKWAY, STE. 700 www.chiefmfg.com
SAVAGE, MINNESOTA 55378 USA 10/06
FLAT PANEL DISPLAY STATIC MOUNT
PSM-2394
(1) Flat Panel Display Static Mount (1) 10-24 x .5 Phillips Flat Head Screw
(1) Latching Flag (1) Nylon Washer
(4) M4 x 25mm Phillips Head Screw (4) M4 x 20mm Phillips Head Screw
(4) Mounting Buttons-Yellow Zinc (1) 10-24 Nylock Nut
BEFORE PROCEEDING: Unpack the carton, verify contents shown in Figure 1 and read
installation instructions completely. If you are missing any of the listed components, please
contact Customer Service at 1-800/582-6480.
Displays are Extremely Fragile.
1. Attach latching flag to mount using the 10-24 Phillips flat head screw, Nylon washer, and
Nylock nut (see Figure 2). Tighten until friction will hold the flag in place.
2. Attach mounting buttons to display using four M4 screws provided (see Figure 3 &
Figure 4).
CAUTION!
Figure 2
Figure 1
Figure 4
Figure 3

3. Securely anchor the flat panel display static mount to wall studs or supporting framework
(see WARNING).
4. Make sure the flag is lowered to the side before attempting to place the display on the mount.
5. With the aid of another person, lift the display up to the mount, align the mounting buttons
with the teardrop slots in the mount, and set the display into place (see Figure 5).
6. Position (raise) the flag to secure the display.
ALL COMPONENTS MUST BE SECURELY FASTENED TO A
STRUCTURAL MEMBER CAPABLE OF SUPPORTING FOUR
TIMES THE COMBINED WEIGHT OF ALL COMPONENTS
PLUS THE EQUIPMENT BEING MOUNTED. IF IT CANNOT
SUPPORT THIS WEIGHT, THE STRUCTURE MUST BE
REINFORCED.
THE MAXIMUM WEIGHT TO BE INSTALLED ON THE
MOUNT IS
175
POUNDS (
79.37
KG).
Figure 5
WARNING