operation manual Status: 11/2021 - Version 1.01
page 1
SMD per series
LED base lights "SMD pro", pluggable or expandable
Product description:
Replace your energy-guzzling lights in the kitchen, living room or
study with these most modern and economical LED lights!
Common technical details:
• Light angle 120 ° • Operation at 230V / 50Hz
• Base - • 100% bright 0 sec. • On / Off 20,000x
• Burn time 30,000 hours. • Power factor> 0.2
• RA> = 80 • Mercury Hg 0.0mg
• Energy efficiency class D • Consumption / 1000h 2kWh
• not dimmable, not suitable for accent lighting
• Connection sockets on both sides
• easy ceiling or wall mounting
• Including 1m 230V connection cable and mounting clips
• each bar can be switched individually
• up to 50 bars can be connected to each other by cable
Safety instructions and important information!
In order to guarantee safety at all times and to use the full range of functions of the device, please
read the safety instructions carefully and carefully!
The product must not be modified technically or mechanically, otherwise the operating license and conformity will
expire with immediate effect! The nameplate / imprint must not be removed under any circumstances! Check the
product for damage before each use. If the product is damaged, it must be checked, repaired or replaced by a
specialist company and disposed of in accordance with the applicable guidelines (footer page 1). Under no
circumstances may a damaged or defective product continue to be used! Please make sure to secure all packaging
material and accessories, especially small parts such as screws and foils, from children and animals. Suffocation
hazard! In the event of non-compliance with the instructions or improper use, the manufacturer Any misuse or
changes made to the product assume no liability for damage to property or personal injury. This product must
never be operated, kept, stored or stored in the reach of children or animals. If this product is passed on, the
instructions and packaging must be included. Thanks! We reserve the right to make misprints or changes to
packaging, the product or the instructions.
Separate safety instructions for 230V installations
The installation or the intervention in the power grid can lead to very serious injuries up to a fatal electric shock. •
Connection or installation may only be carried out by qualified personnel / electricians in a voltage or current-free
state! For all work, completely switch off the circuit in which the installation is being carried out at the main fuse!
Otherwise there is a DANGER TO LIFE !!. To connect all 230V ~ / 50Hz components, the minimum cross-section
(1.5mm²) of the connection cable must never be undershot. Be sure to use a cable and tool that has been expressly
approved for this use. There are no serviceable parts inside this product. The correct connection must be checked;
the voltage may only be switched on again when the installation is correct.
Electronic products that are marked with the crossed-out garbage can do not belong in the household waste! You can hand these products in free of
charge at the municipal collection points. Inquire here at your local authority, the responsible town hall or a local or municipal waste disposal
company. Thanks very much. Used batteries should not be put in the household garbage. Consumers are legally obliged to bring batteries to a
suitable collection point at the trade or local authority. Old batteries may contain pollutants or heavy metals that can be harmful to the environment
and human health. The symbols under the label (garbage can) stand for: Pb: battery contains lead, Cd: battery contains cadmium Hg: battery
contains mercury. The environment and ChiliTec say thank you.
Reproduction only with permission from
ChiliTec GmbH, Bäckerberg 12, 38165 Lehr
EAR (WEEE): DE25841852
LUCID Packaging Act: DE5562476395648
GRS (UBA register) no .: 21003466
Translated from German to English - www.onlinedoctranslator.com
