Chima SON8016U GEPON SYSTEM ONU User manual

SON8016U GEPON ONU User Manual
陈泽科技有限公司 www.stephen-tele.com
SON8016U GEPON SYSTEM ONU
User Manual
STEPHEN TECHNOLOGIES CO.,LIMITED
ALL RIGHTS RESER ED

SON8016U GEPON ONU User Manual
陈泽科技有限公司 www.stephen-tele.com
CONTENTS
Chapter 1: Product introduction
1. Goods listin
2. Front panel instruction
3. Back panel instruction
4. Indication li ht instruction
5. Main feature
6. Technolo y
Chapter 2: Installation and link
1. Attention items for settin
Chapter 3: software upgrade
1. Preparation
2. Means and process
Chapter 4: Remark
Chapter 5: Annex
Chapter 1: Product introduction
1. Goods listing
Open the packa e of fast Ethernet switch, and it contains the followin :
A set of ONU, A power supply, a user’s manual and a stream line
Please contact with supplier if above product and accessory is missin or dama ed.
2. Front panel instruction
Front panel of ONU have 20 kinds of status indicators, as the followin picture
3. Back panel instruction:
Back panel of ONU from left to ri ht in turn is PON Port, Six RJ45 Ports, a bunch port, a replacement switch
and a power supply jack, as followin illustrate.
4. Indication light instruction
The si nification of indicator from left to ri ht is as followin :
LED Color
Status Description
POW
Green
li ht the indicator will li ht when ONU is opened.
-- Non-li ht
Checkin the TX or power supply adaptor, make sure power supply
has connected well.
OPT Green
li ht Checkin the TX or power supply adaptor, make sure power supply
has connected well.
-- Non-li ht
Optic link is ok.
HW Green
li ht Hardware is error
-- Non-li ht
Normal work status
LLID1
-8
Green
li ht Optic link is ok
-- Non-li ht
Checkin optic link is ok or not

SON8016U GEPON ONU User Manual
陈泽科技有限公司 www.stephen-tele.com
100M Green
li ht Correspondin indicator will li ht when 100Mbps equipment
connect with relevant port.
-- Non-li ht
Non-li ht 100Mbps port does not joint equipment.
LINK100
Green
li ht Li ht when 100Mbps equipment link to relevant port
-- Non-li ht
Non-li ht when 100Mbps port does not joint equipment.
LINK1000
Green
li ht Li ht when 1000Mbps equipment link to relevant port
-- Non-li ht
Non-li ht when 1000Mbps port does not joint equipment.
DUP/
COL
Green
li ht Li ht when port is workin base on full duplex mode
-- Non-li ht
Non-Li ht when port is workin base on half duplex mode
ACT Green
Li ht Li ht when equipment normally connect with 100Mbps ONU port
Green
litter Glitter when the port receive or transfer data
5. Main feature:
●Support sin le fiber WDM technolo y (downstream 1490mm, upstream 1310mm), only need to link with OLT
to ether by one fiber, the transfer len th’s at least 20Km.
●Bandwidth distribution has flexible, downstream share bandwidth by adaptin encrypt broadcast transfer
way for different user. .Upstream share bandwidth by TDMA . Adjust automatically speed rate accordin to the
line status. Support minimum speed rate adjustment base on 1kbps, and establish firm basic to fractionize
business for telecommunication dealer.
●Support enerally team broadcast function. User can choose to achieve mutual video multimedia business by
themselves name (such as VOD, Video conference)
●Bind user, MAC address and IP address to ether in order to prevent account was embezzled hostility, ramble,
virus spread abroad and attack of hostility data stream., so that can provide perfect safety uarantee measure
for user.
●Support multi LLID and sin le LLID confi uration mean. Different user and business can adapt different LLID
access. Guarantee user’s different OOS rade.
Installation and maintenance are very easy. Support differed local/lon -distance and many means to mana e
confi uration and up rade of software. Work in partial port OLT. It can make lon -distance malfunction
dia nosis and orientation function come true, and reatly reduces maintenance workload.
●Network connects: Provide hi h speed date business for user.
●FTTB connects: adapt the mean of fiber to corridor or bi corridor to provide hi h speed data business.
Physics feature
●Physics dimension (len th240 x width117 x hi h30, unit: mm)
●Power supply：DC 5V
●Function loss：8W
●Temperature：
Operatin temperature：0～50℃
Stora e temperature：-30～60℃
Relative humidity：10～90% (non-condensation)
●Wei ht：1KG
Technology guide line:
Standard :IEEE 802.3ah、IEEE 802.3、IEEE 802.3u、IEEE 802.3x、IEEE 802.3z 、IEEE802.1d、IEEE 802.1p、IEEE
802.1q、IEEE 802.1x、RFC1155、RFC1157、RFC1112、RFC1113 and so on.
●Five fixed 10/100M BASE-TX Port
●A fixed 10/100/1000M BASE-TX Port
●128 di it AES Encrypt
●Support 8 lo ic link.
●Each Ethernet port support 64 Mac Addresses based on 802.1D Brid in

SON8016U GEPON ONU User Manual
陈泽科技有限公司 www.stephen-tele.com
●Support 802.1Q VLAN
●Support 802.1P
●Support 40 stream (20 upstream/20 downstream)
●Inbuilt 1.25 MB bufferin
●Support 802.3ah OAM
●Support 802.3ah transfer error and revise
●Inbuilt MIB
Chapter 2: Installation and link
1. Attention item for setting
Please insure that there is suitable work environment and enou h free space before installin machine. Please
note the installin requirement as followin :
Power supply requirement: 100v-240v alternatin current, power supply jack and equipment should be within
1.8m.
Machine should be putted in the ventilated and dry environment, there must leave 10cm free space from
front to back of machine to airiness
Insure that around for machine has enou h airiness port in order to diffuse quantity of heat, at the same time;
don’t put anythin heavy on the converter.
Chapter 3：
：：
：Software upgrade
As below introduction of software up rade is available for sin le ONU. If it is mixed with our OLT, It’s better to
operate it in the OLT’s mana ement section depend on professional people.
3.1 Preparationz
1. A PC with RS-232-C port, a RS-232 stream line.
2. prepare Tera Term software in PC.
3.Prepare up rade document: Boot3713_0093_SPI_8Mb.tkf,App3713_R132_SPI_8Mb.tkf，Pers3713_R132.tkf
3.2 Means and process:
1. Start PC, and click “Tera Termpro”, then start the up rade software.
2. Set software, as followin chart:

SON8016U GEPON ONU User Manual
陈泽科技有限公司 www.stephen-tele.com
3. Connect ONU with relevant bunch port on the PC RS-232, then turn on the power, as followin chart:
4. As the dos prompt shown above, input load order as followin chart:

SON8016U GEPON ONU User Manual
陈泽科技有限公司 www.stephen-tele.com
5. Firstly, up rade Boot code, as followin dos prompt input ”rxboot” click the ”file” and choose “send file” , then
“Boot3713_00XX_SPI_8Mb.tkf” you want to up rade, as followin char:
Click “open”, start to up rade”bootcode”, as followin chart:

SON8016U GEPON ONU User Manual
陈泽科技有限公司 www.stephen-tele.com
6. As above method, up rade ”app”, “pers” in turn. Input”rxapp” order while up rade “app”
choose”App3713_Rxxx_SPI_8Mb.tkf” file, input “rxpers” order when up rade “pers”, choose”Pers3713_RXXX.tkf” file.
7. After finishin the up rade. Pls restart ONU to check if the status is ok or not..
Chapter 5. Annex
(100M 5 port management methods -optional)
ONU No. 2 to No. 6 RJ45 port is 100M port.
This five-port mana ement is a choice, if you did not choose this mana ement functions, machines will be
workin in accordance with the default mode.
ONU five of the port mana ement 100M There are two ways:
The first one: with OLT connected computer directly on the importation of this five-port mana ement chip
address (192.168.0.100) into the mana ement interface.
The second: 100 M arbitrary port throu h a network of computers connected with the computer input
mana ement chip address (192.168.0.100) to enter mana ement interfac e.
Please refer to attached document for the details.
5.1 Software Introduction
The switch is Web based mana ement basic on IP address. Firstly. Please set an IP address for PC accordin to switch’s
default IP address ，and make sure the switch and PC must be in the same ateway. Please open web browser,
input the switch IP address, for example：http://192.168.0.100, and input the user’s name and password
（default user’s name is “admin”，Password is “1234”）, then you mi ht enter into the mana ement interface.

SON8016U GEPON ONU User Manual
陈泽科技有限公司 www.stephen-tele.com
5.2 Administrator
The master should lo in on the user lo in pa e. Only after entered the mana ement pa e, the master can
mana e IP setup, browse system conditions, reset ori in setup and update it’s version.
5.2.1 User name and password
The master must use the exact user name and password to lo in. The master can amend the User name
and password after lo in.
5.2.2 System IP setup
It includes the setup of IP address, subnet mask, and ateway. The master may mana e the switch after
you set the same ateway of PC and the switch.
5.2.3 System status
System includes MAC address, number of ports, comment and system Version. You may check the
system condition when you enter into the pa e.
5.2.4Load default setting
The user may reset the switch ori inal setup if it is required. The switch is with ori inal setup on the first
usin .

SON8016U GEPON ONU User Manual
陈泽科技有限公司 www.stephen-tele.com
5.2.5 Update version
This function is to update the firmware. The system may update the system software. Please operate
exactly like the menu when you update the firmware.
5.3 Port management
5.3.1 Port Configuration
This function is to set port rate, full/half duplex, auto-ne otiation and data-communication
5.3.2 Bandwidth control
5.3.3 Broadcast storm control
It can leach the internet Broadcast Storm. When the function is on, the ports will abandon the broadcast
frame when it reach the maximum rate. If the function is off or the broadcast storm dose not reach the
maximum rate, the broadcast frame will be broadcast to the switch ports.
5.3.5 Max Packet Length control
This function is for setup max. data packet len th, which default rate is 1536 byte.

SON8016U GEPON ONU User Manual
陈泽科技有限公司 www.stephen-tele.com
5.4 LAN setting
5.4.1 LAN Groups setting
You can set max. four VLAN roups in one ONU Switch. There are max. 8 member ports in one VLAN
roup. The member ports of the same VLAN roup can be communicated each other.
5.4.2 LAN Multi to One Mode
This function re ards ports as tar et VLAN, other ports can add into this tar et VLAN port as a VLAN roup.
But after this function is active, the ori inal setup of the VLAN roup may be replaced or cleared.
5.5 QoS setting
5.5.1 Class of Service Configuration
You may setup the priority of data packet forwardin by port base. The hi h priority port mi ht forward
the data packet first.
5.5.2 High Priority Queue Configuration
This function is for priority queue confi uration of switch for Wei ht-Round-Robin low wei ht 1/4 and
1/8.

SON8016U GEPON ONU User Manual
陈泽科技有限公司 www.stephen-tele.com
5.5.3 Customization differentiate serving setting
Activatin this function may differentiate PRI throu h some certain bits of packa e received. After
activatin a certain serial number, the switch will distin uish each received data packa e with this serial
number to see if this data packa e is hi h priority packa e, if yes, it will be switched as priority.
5.6 Port security setting
After power on reset, each port will record the first receivin data packet’s source MAC address as “security
MAC address”. A security port only allows that data packet which has the” security MAC address” to active on.
Copyright Notice:
No part of this document may be reproduced, transmitted, transcribed, stored in a retrieval system, or
translated into any lan ua e, in any form or by any means, electronic, mechanical, ma netic, optical, chemical,
manual or otherwise without the prior written permission of Stephen Technolo ies Co.,Limited.
Disclaimer Notice:
No license is ranted, implied or otherwise, under any patent or patent ri hts of Stephen Technolo ies
Co.,LTD. Stephen Technolo ies Co.,LTD, makes no warranties, implied or otherwise, in re ard to this
document and to the products described in this document. The information provided by this document is
believed to be accurate and reliable to the publication date of this document. However, Stephen Technolo ies

SON8016U GEPON ONU User Manual
陈泽科技有限公司 www.stephen-tele.com
Co.,LTD assumes no responsibility for any errors in this document. Furthermore, Stephen Technolo ies
Co.,LTD, assumes no responsibility for the use or misuse of the information in this document and for any
patent infrin ements that may arise from the use of this document. The information and product
specifications within this document are subject to chan e at any time, without notice and without obli ation
to notify any person of such chan e.
STEPHEN TECHNOLOGIES CO.,LIMITED
601, Buildin NO.18, Kan Daer Area, BuJi Town,
Lon Gan District, Shenzhen, G.D, China, 518112
Tel: [phone]
Fax:[phone]
Website: www.stephen-tele.com
Email: [e-mail]