ChocoVision Chocolate Dispenser User manual

ChocoVision Corp.
14 Catharine St., Poughkeepsie, NY 12601
Phone: [phone] Fax: [phone]
chocovision.com
ChocoVision
Chocolate Dispenser
REPLACEMENT PARTS
Clamp Assembly 5/10-
Motor Assembly-
Barrel Assembly-
Auger-
Power Supply with Speed Control and Chord-
Clamp Assembly 30-
CLEARING THE BARREL
Rotate the Speed Control Knob counter clockwise until the Auger stops.
Open the Clamp Lock and raise the Barrel Assembly so the Inlet is out
of the chocolate in the Tempering Bowl.
Move the Direction Switch on the Power Supply to “reverse”, and restart
the motor by rotating the Speed Control Knob. Residual Chocolate will
be returned to the Tempering Bowl.
CLEANING
Unplug the Power Supply from the Motor Assembly and lift the
Open the Clamp, remove the Barrel and Auger, and move these to the
cleaning area.
Remove the Auger from the Barrel.
Grip the Barrel and unscrew the Inlet and Discharge by rotating them
Clean the Barrel, Inlet and Discharge with a sti brush, and screw
back together when dry. Note: Barrel, Inlet, and Discharge are not
dishwasher safe. Cleaning these parts in a dishwasher will warp
them and void your warranty.
IMPORTANT: Components must be thoroughly dry before
reuse to prevent contamination of the chocolate.
8AS-1003-001
8AS-1001-001
8AS-1002-001
8PL-1008-001
8EL-1001-001
8AS-1005-001

Fig.1
Fig.2
Fig.3
Fig.6
Fig.4
Fig.7
Fig.8
INSTALLATION AND SET UP
Attach the Clamp Assembly to the Tempering Machine
pushing the inside of the Clip against the Rail, and tightening
The discharge end of the Barrel Assembly can be rotated to dispense on either side
Align the Motor Assembly dovetail with its mate on the Barrel Assembly discharge,
and rotate the Auger so the Drive Pin will engage a slot on the Motor Coupler as
Rotate the Speed Control Knob on the Power Supply (Fig.5) counter clockwise and
put the direction switch on the Power Supply at “forward”. Connect the Power Supply
cord to the Power Supply, and plug the Circular Connectors from the Power Supply
into the Receptacles on the Motor Assembly. See Fig.6
Plug the Power Supply into a 115V receptacle.
bottom of the Tempering Bowl. See Fig.7
OPERATION
commence by rotating the Speed Control Knob on thePower Supply clockwise.
Starting dispenser with partially melted chocolate or with solid residue in the barrel
may damage the device.
Fig.5
Knob
Metal Clip
Rail
Clamp
Assembly
Clamp
Lock
Drive
Fin Dove
Tail
Auger
Barrel
Assembly
Barrel
Discharge
Inlet Inlet
Direction
Switch
Speed Control
Knob
Power
Supply
Motor
Coupler
I.
II.
III.
IV.