
PLANETARY MIXER
MANUAL
9
Maintenance
AND TROUBLE SHOOTING
Maintenance
Clean the bowl and stirrer daily or afteruse to maintain hygiene standard.
The transmission gear box is greased in factory. Check the greasing every 6 months. To assess or
rellgrease,openthetopcover,thenllgreasefromapertureorreplacethegreasedirectly.
Trouble Shooting
Problems Causes Solutions
Tool shaft does not rotate after
starting the machine Loosen electric wiring Check electric wiring, tighten
those loose connects
Oil leakage The seal rings are worn out Replace seal rings
Motor temperature raised
while reduced output speed
Too low voltage Check the power supply
Overloaded Reduce load
The speed of mixing is too high
or using a wrong stirrer
Select a suitable speed and
stirrer
The mixing knocks with the
bowl The stirrer bowl is deformed Repair or replace the stirrer or
bowl
Abnormal noise and high
temperature from gearbox Insucient lubrication Add or replace the grease
Warning!
If the equipment is out of function, please make sure that it is serviced by a professional person
or please turn to special service point.
Mixer will NOT START unless:
Bowl is secure in up position
Unit plugged in
Timer is enabled
Safety guard is closed