Cisco C460 M4 User manual

Contents
Introduction
Problem
Potentially Impacted Systems:
Customer Visibility / Impact:
Solution
Work Around Options:
Work Around 1 - Reset the IMC to Factory Default Settings
Work Around 2 - Resetting to Factory Defaults via IMC CLI
Introduction
The intent of this document is to address the issue seen regarding Trusted Platform Module (TPM)
related System Event Logs (SEL) events on some C460 M4 servers. A small number of C460 M4
SPARE servers will see a critical SEL event related to TPM presence right out of the factory. The
instructions below will assist you in resolving servers impacted by this issue.
Problem
Potentially Impacted Systems:
About 614 SPARE C460 M4 Systems (Shipped between June 2nd 2014, and April 13th 2016.)
Customer Visibility / Impact:
Customers may see a critical SEL event similar to the one below on servers received from the
factory.
There is NO operational impact to the server, but the message may lead to unessary concern
resulting in a call to TAC. This has to do with the way TPMs were handeled in manufacturing.
C460 M4 systems keep a "Cached" value for TPM presence, indicating if a TPM was was ever
installed in the server - every server has a TPM installed durring testing. The C460 M4 also tracks
the current precense of the TPM, and since all servers ordered as spares ship without a TPM, the
system triggers an alarm thinking that the module that was once installed has been removed.
Solution
The work-arround below will allow you to quickly address this SEL event should you wish to
remove the messages. The work-arround involves resetting the Integrated Management Controller

(IMC) to factory default settings, clearing any cached TPM Presence value.
Work Around Options:
Work Around 1 - Reset the IMC to Factory Default Settings
Resting to Factory Defaults via IMC WebUI
Point a browser to the IMC IP, login, and navigate to the Admin --> Utilities tab1. Click the "Reset Cisco IMC to Factory Default Configuration" as shown in the image below.2.
3. You will be prompted with a pop up box. Click OK to proceed.
Note: The IMC will reset completely and you will need to reconfigure all settings. Please record
any information prior to the reset.

Work Around 2 - Resetting to Factory Defaults via IMC CLI
SSH to the IMC IP using the user's credentials.1. Type the following commands as shown below:2.
a. scope cimc
b. factory-default
3. Enter "y" to continue.
Note: The IMC will reset completely and you will need to reconfigure all settings.
Please record any information prior to the reset.