Cisco IE3400H Guide

Switch Mounting
•Switch Mounting, on page 1
Switch Mounting
This chapter describes how to mount the switch.
Mounting the Switch
To prevent the switch from overheating, ensure these minimum clearances:– Top and bottom: 2.0 in. (50.8
mm)– Exposed side (not connected to the module): 2.0 in. (50.8 mm) – Front: 2.0 in. (50.8 mm)
Caution
Installing the Switch on the Wall
To attach the switch to a wall or a panel, follow these steps.
Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct hardware
or to follow the correct procedures could result in a hazardous situation to people and damage to the system.
Statement 378
Warning
Procedure
Step 1 Position the switch mounting bracket against the wall or a panel in the desired location, with the arrow pointing
up. See the following figure. Attach the bracket to the wall with the 4 enclosed Philips screws.
Switch Mounting
1

Figure 1: Mounting Wall Bracket to Wall
When attaching the bracket to the wall or pannel, ensure that the screws engage a stud or support
structure capable of supporting the weight of the bracket and the switch.
Note
Step 2 Loosly attach the 4 mounting screws to the switch and slide it into the bracket and down. See the following
figure.
Switch Mounting
2
Switch Mounting
Installing the Switch on the Wall

Figure 2: Attaching the Switch to the Mounting Bracket
Step 3 To remove the switch, loosen the 4 mounting screws and slide the switch up and forward, out of the mounting
bracket. Then the bracket itself can be unscrewed from the wall, if necessary.
What to do next
After the switch is mounted on the wall or panel, connect the power and alarm wires, as described in the
“Connecting Alarm Circuits” section on page -12 .
Switch Mounting
3
Switch Mounting
Installing the Switch on the Wall

Switch Mounting
4
Switch Mounting
Installing the Switch on the Wall