Clarigo C11 User manual
C11
User’s Guide
Start Configuration
Reset to default
Firmware Version
End Configuration
< >
with USB Interface
Make the barcode lab el as f l at as p ossible when it is distorted.
The C11 scanner may not read la bels under direct sunshin e or in
extreme ly bright places.
It is possible to read barc odes that are upside down.
It is possible to read Inverse as well as No rmal 1D bar codes.
If a barcode label is covered with a plastic sheet or film, remove the covering
before scanning the barcode.
When consecutively reading the same barcode twice or when the C11
scanner is set to consecutive reading mode, be sure to hold the barcode C11
scanner reading window a sufficient distance away from the barcode being
read for approximately 1 second. Then read the next barcode after the
indicator LED turns OFF.
connec ted success fully .
Please w ait for few seconds , Window s automatically c onfigures until
Upon com pletion of instal lation, the f inish screen appears instead o f
the screen above. Click Fini s h to re turn to Windows.
the scan ner.
Other manuals for C11
1
Table of contents
Other Clarigo Barcode Reader manuals
