Clarke 7310000 Instruction Manual

OPERATION & MAINTENANCE
INSTRUCTIONS
LS0112
FLOOR CLEANER
PART NO: 7310000

2
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
INTRODUCTION
Thank you for purchasing this CLARKE Floor Cleaner.
Before attempting to use this product, please read this manual thoroughly and
follow the instructions carefully. In doing so you will ensure the safety of yourself
and that of others around you, and you can look forward to your purchase
giving you long and satisfactory service.
GUARANTEE
This product is guaranteed against faulty manufacture for a period of 12
months from the date of purchase. Please keep your receipt which will be
required as proof of purchase.
This guarantee is invalid if the product is found to have been abused or
tampered with in any way, or not used for the purpose for which it was
intended.
Faulty goods should be returned to their place of purchase, no product can
be returned to us without prior permission.
This guarantee does not effect your statutory rights.
GENERAL SAFETY RULES
1. ALWAYS read the safety instructions that are supplied with your pressure washer and
accessories.
2. NEVER direct the spray towards electrical wiring or equipment.
3. ONLY trigger the pressure washer when the floor cleaner is flat against the floor being
cleaned.
4. NEVER allow children or untrained personnel to use this machine.
5. NEVER reach under the edge of the floor cleaner whilst the device is in operation.
6. NEVER use the detergent bottle to introduce flammable liquids/solvents, e.g. paint
thinners, petrol, oil as there is a risk of explosion.
7. ALWAYS turn off the pressure washer after use and before carrying out any
maintenance on the floor cleaner.
8. ALWAYS wear protective clothing and safety glasses. Loose particles and other
debris may be propelled at high speed by the water jet.
9. ONLY use chemical cleaning agents (detergents), that are approved for pressure
washers. CLARKE Traffic Film Remover (available from your dealer) is
recommended.

3
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
BEFORE USE
ATTACH THE FLOOR CLEANER TO THE PRESSURE WASHER
1. Slide the spigot end of the floor
cleaner accessory into the handle
assembly.
2. Push in firmly and twist 90° to lock
it into position.
APPLYING CHEMICALS AND CLEANING AGENTS
1. Ensure the trigger lock is in the locked position and the pressure washer is
switched OFF.
2. Remove the lid from the
detergent tank and fill with the
required amount of detergent.
• Only use detergents
recommended for use with
pressure washers, such as
CLARKE Traffic Film Remover
which is a powerful low
foaming agent for patio
cleaning etc.
3. When the tank is filled with detergent, replace the lid.
USING YOUR FLOOR CLEANER
1. Activate your pressure washer according to the instructions supplied with
the pressure washer.
2. Slowly move the floor cleaner over the surface being cleaned.
• Make sure you keep the floor cleaner parallel to the floor.
3. When cleaning the edge of the patio, do not allow the floor cleaner to tip
over the edge, as this may damage the floor cleaner if the rotating brush
strikes the edge on the patio.