Clarke GWC1 User manual

WELDING CART
Model No: GWC1
Part No: 6601995
Thank you for purchasing this Welding Cart, specifically designed for use with MIG welders, to provide a more
compact unit and improve mobility in and around the workshop.
Pleasereadthefollowinginstructionscarefullyandensurethatanyoneusingthisunitisfullyaware of the precautions
to be taken when it is put to use. NOTE: 10mm spanners are required to assemble this cart.
SAFETY PRECAUTIONS
• Ensure the welder and gas bottle plus any tools are completely secure before transporting.
• Be aware that the cart could become top heavy, depending upon the tools carried etc.
• Tighten the cylinder chains as tightly as possible to prevent the cylinders from moving during transit.
• NEVER attach the welders earth lead to the cart....a proper earth is vital to the welding process.
• Use the cart on flat, smooth surfaces only.
• DO NOT position cart on sloped surfaces.
• NEVER pull cart by the welder leads
ASSEMBLY
SPARE PARTS
No: Description Part No:
1 Bottom Tray QGGWC101
2 Wheel QGGWC102
3 Caster QGGWC103
4 Front Panel QGGWC104
5 Middle Tray QGGWC105
6 Top Tray QGGWC106
7 Side Support QGGWC107
8 Torch Assy Bracket QGGWC108
9 Axle QGGWC109
- Nuts bolts and washers N/A
11 Flat Washer and Split pin N/A
12 Plastic Cap QGGWC112
No: Description Part No:
For Spare Parts, contact your local CLARKE dealer, or Clarke International on: 020 8988 7400
1. Slide the axle through the housing in the bottom
tray, and slide on to each end, a flat washer,
followed by a wheel and finally secure using the
split pin provided.
2. Fit the casters to the bottom tray using four nuts,
bolts and washers provided.
3. Fit the side supports to the bottom tray in the
manner shown in the illustration.
4. Fit the middle and top trays to the side support,
loosely, then attach the front panel.
Beforetighteningthenuts,shake the structuretoensure
that no part is under stress, then, ensuring the structure is
square, tighten all nuts, except the top right hand nuts of
the side supports. Remove these and attach the Torch
AssemblyBrackets,thenreplacethe nuts andtightensecurely.
5. The gas bottle sits in the tray, supported by the front panel and
secured by chains, entered in the slotted holes in the front panel.