6
English
N
N
L
L
Ceiling cable
Wires to the light source
Connection block
= Earth (Yellow-Green)
L= Live (Brown)
N= Neutral (Blue)
Theinstallation should only be performed by those with knowledge of electrical wiring. If unsure,
contact aqualified electrician. Carefully read theinstructions before theinstallation.
Caution! Closely check that thepower is shut off before starting theinstallation.
1. Fasten theceiling light onto theceiling in
anappropriately secure manner.
Use theincluded screws.
2. For ceilings made of concrete or similar
material: Use thelight fixture’s base as
atemplate and mark out where thedesired
mounting holes are to be drilled. Drill two
6 mm mounting holes, insert anchor plugs
into theholes and use theincluded screws
for mounting thelight fixture securely onto
theceiling. Watch out for hidden pipes or
electrical wiring.
3. Thread theincluded wire insulators (h) over
theincoming mains electrical wires. Then
connect these wires to theterminal block (g)
according to thewiring diagram.
4. Screw in alight bulb (max 60 W, E27).
5. Unscrew one of thediffuser’s retainers (f).
Mount theglass diffuser. Refit thescrew
and tighten, ensuring that thediffuser sits
securely in place.
Care and maintenance
• Switch off thepower to theceiling light before cleaning.
• Clean thelight using asoft, damp cloth. Use amild detergent. Never use solvents or strong,
abrasive cleaning agents. These could possibly damage theproduct.
Disposal
This product should be disposed of in accordance with local regulations.
If you are unsure how to proceed, contact your local council.
Specifications
Max bulb wattage 60 W, E27 (sold separately)
Input voltage 220–240 VAC, 50 Hz
Diam 31 cm
Class 1, IP20 (this light fitting must be earthed)
