Classic Exhibits VISIONARY DESIGNS MOD-1345 Manual

© 2023
Order #XXXXX
Locked layer contains
placeholder marks.
USB Extension Cord
Base
Plate
Post
Mounting
Plate
Clamshell
Acorn
Nut
Steps:
1) Attach base plate to straight end of post, using bolt.
2) Attach mounting plate to curved end of post, using bolt.
NOTE: Plate must rotate to left and right before installing clamshell.
3) Attach clamshell to mounting plate, using acorn nuts.
See Clamshell Attachment detail.
4) Insert iPad in clamshell, then route cords through holes. See
Cord Management for iPad detail.
5) Attach graphics to post using A10 clamps. See A10 Clamp detail.
Clamshell Attachment Cord from iPad
Cord Management For iPad
Attach iPad cord to supplied USB extension
cord. Feed USB cord through top hole of
post, then out bottom hole of post.
connect to power.
Cord
Access
iPad
Lock Lock
Clamshell
Foam Lining
Removed
Home Button Shield
Optional Cover for Home Button
1) Remove foam lining from inside bottom of
clamshell.
2) Attach Home Button Shield with double-sided
tape to inside of clamshell, keeping top of
shield flush with clamshell opening.
NOTE: This is a permanent fix and can’t be
easily removed.
Graphic
Graphic
Knob
Set Screw
Connector
1) Slide connector of clamp
into extrusion groove.
2) Tighten set screw when
A10 is in desired location.
3) Insert graphic into clamp.
4) Tighten knob on clamp
to secure graphic in place.
A10 Clamp
A10 Clamp
Completed Assembly
Rotate clamshell
to turn iPad from portrait
to landscape orientation.
MOD-1336 iPad Kiosk
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
SETUP INSTRUCTIONS

© 2023
Order #XXXXX
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
Part Identification - Numbering
Spline Connection Base Plate & Extrusion Connection
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all set screws
and locks during disassembly.
7A
Hex Tool - Essential for Assembly
Extrusion & Lock Connection Engaged Lock
LADDERS OR LIFTS
MAY BE REQUIRED
General Information