Classic Exhibits visionary DESIGNS MOD-1355 User manual

www.classicexhibits.com
866.652.2100
© 2013
WHEN DISASSEMBLING, TIGHTEN ALL SCREWS AND NUTS TO PREVENT LOSS DURING SHIPPING.
MOD-1355 - iPad Kiosk
Infill
2
3
4
1
When assembled
*
*
*
Attach connector piece to tray
as shown. Then connect
assembled pamphlet
tray to vertical extrusion.
Adjustable Pamphlet Tray Attachment
Tighten Lock
to Secure
Wire
Access
iPad
Lock
Lock
Foam Lining
Removed
Home Button Shield
Optional Cover for Home Button
1) Remove foam lining from inside bottom of
clamshell as shown.
2) Attach Home Button Shield with double-sided
tape to inside of clamshell, keeping top of
shield flush with clamshell opening as shown.
NOTE: This is a permanent fix and can’t be easily
removed.
Steps:
1) Slide infill between stand verticals as shown.
2) Attach horizontal [2] between stand verticals.
3) Attach base [1] to stand verticals using bolts.
4) Attach square plates [3] to stand using bolt.
5) Attach clamshells [4] to square plates [3] using hex nuts.
6) Insert iPads and feed wires through hole.
7) Attach pamphlet trays to stand. Refer to detail.
Clamshell
Side View
Stand
Base
Plate
Square
Plate
Square
Plate
Hex
Nuts
Hex
Nuts
Tools Required:
1) Hex Tool
2) Pliers

www.classicexhibits.com
866.652.2100
© 2013
WHEN DISASSEMBLING, TIGHTEN ALL SCREWS AND NUTS TO PREVENT LOSS DURING SHIPPING.
MOD-1355 - iPad Kiosk - Case Packing Instructions
Literature Pockets
Setup Hardware
Base Plate
Level 1 Level 2
Top View of Each Level
2
1
Assembled iPad Stand