Cleanfix S 10 User manual

www.cleanfix.com
Cleanfix Reinigungssysteme AG
Stettenstrasse 15
CH-9247 Henau-Uzwil / SG
Tel. [phone]
info@cleanfix.com
S10
Item No.: 022.000
S10 plus / S10 plus Eco
Item No.: 022.010 / 022.010E
User manual
Vacuum Cleaner
S10 / S10 plus
Cleanfix / S10 user manual / 03.2020

www.cleanfix.com
S10 / S10 plus
1
6
10
15
2
7
11
16
1
3
8
12
17
2
4
9.1
13
18
3
5
9.2
a
a
a
b
b
b
14
19
4
Unwind power cable
Check the cable, replace it if
damaged
Optional: HEPA-Filter
Replace it if heavily soiled
Switch on vacuum cleaner
Connect the power cord to
power and press the switch
Clean vacuum cleaner
Wipe the entire vacuum clea-
ner with a slightly damp cloth
Insert dust bag
We offer dust bags from:
- Textile
- Fleece
- Paper
Read the operating instructions before commissioning the machine!
Cleanfix Service-Hotline: [phone]
Open vacuum cleaner
Release the black flap and lift
the upper part
Check motor filter
Replace it if heavily soiled
Combi floor nozzle
Carpet setting (a)
Hard floor setting (b)
Winding up the cable
Wind the cable tightly under
the black ring
Clean the dust bag connec-
tion in the vacuum cleaner if
necessary
Lift out filter basket
Replace it if heavily soiled
Motor filter
Correctly inserted filter
Missing air supply
To clean soft textiles, open
the air vent
Insert suction rod
Insert the slide clamp (a) at
the handle (b) (model S10 plus)
Insert the dust bag
Observe the ”Top Oben”
mark on the dust bag
Check dust bag
If it is full, replace it (see ”In-
serting the dust bag” below)
Close vacuum cleaner 1
Step 1: Guide the upper part at
a slight angle into the tab (a)
Clean combi floor nozzle
After use, remove the nozzle
and vacuum it
Suction rod inserted
Only possible with the models
S10 plus
Plug in the dust bag tightly
Insert filter basket
Freely applicable, without
predetermined position
Close vacuum cleaner 2
Step 2: Press the flap (b)
again
Switch off vacuum cleaner
Press the switch and dis-
connect the power cord
Storing vacuum cleaner
Optionally wrap the hose
around the suction tube
Make sure that the dust bag
is evenly positioned
User manual