10
switch to pos. 1, brushes motor start. The brushes will be lowered to the floor pushing on the brush
plate lowering block. Now operate immediately the lever to apply the detergent water, and adjust it
accordingly. Put the run selector (fig.2) in its forward position and press the pedal (fig.3) so that the
machine moves forward and starts scrubbing. The water dosage must be adjusted to get the whole
surface completely wet after the brush passage, but without any excess, that could generate
splashes, stream or flows out of the squeegee. If no double scrubbing is not performed, lower the
squeegee after placing the run switch in forward position. The squeegee is lowered by means of the
pedal. The vacuum motors are operated by means of the switch. Once the scrubbing and drying
procedure are finished, first of all close the water with the lever , then lift the brushes by means of
the pedal and the squeegee by means of the pedal. Finally, turn the motors off.
WATER FILLING AND DISCHARGE, TANK CLEANING
Before every scrubbing operation, open the door and fill the solution tank with the right quantity of
water and cleanser. The tank is made of polyethylene resistant to all acid and basic solution and to
all dissolvents found on the market. At the end of the scrubbing operation, discharge the dirty water
from the tank by means of the hose. Accurately clean the tank at least once per week.
SQUEEGEE ADJUSTMENT
The squeegee must be perfectly adjusted to get a perfect floor drying ( fig. 8).
The main characteristic of this type of squeegee is to pick-up the water from the floor and convey to
the vacuum hose, but it must be parallel to the floor. To rightly adjust the squeegee operate as
follow:
Extract the key from the control dashboard to avoid accidental start of the machine.
oTo adjust the squeegee slope operate the knob (fig 3).
oThe right pressure is got when the edge of the rear blade touches the floor with a slating of
approx. 60°-45° referring to the floor.
Fig. 3
Note that often drying is negatively affected by a wrong suction operation. If the suction hose
doesn’t work well, drying will continue to be bad, even with all adjustments attempts. In this case:
a- accurately clean the suction hoses, their inlets and filters and the squeegee itself.
b- check the vacuum motors operation.
c- confirm that all inspection openings of the tank are closed.
1. handle position adjustment knob
2. solution adjustment lever
3. battery charge plug
4. squeegee lifting lever
5. brush lifting pedal
6. squeegee slating adjusting knob
7.
