Cleveland GMC1 User manual

Cleveland
™
Project ________________________________
Item __________________________________
Quantity_______________________________
FCSI Section ____________________________
Approval _______________________________
Date __________________________________
1333 East 179 St.,
Cleveland, Ohio,U.S.A. 44110
Tel: [phone]
Fax: [phone]
Web Site:www.ClevelandRange.com
Email: [e-mail]
OPTIONS & ACCESSORIES
Wall or Stand Mounted Models:
cMODEL GMF - U.S GALLONS
cMODEL LMF - LITERS
Cleveland Standard Features
nAutomatically meters and dispenses water up to a
maximum temperature of 80° F. (27° C).
nAll 304 Stainless Steel Exterior Construction.
nPower On/Off Switch controls operation.
nWater Resistant Controls and Switches.
nAdjustable Volume Setting Indicator to measure the
correct amount water requirements.
nDigital LED readout indicates gallon output during
operation.
nStart Switch with Reset and Continue Mode operation
for starting and stopping in-between filling operation.
nInterrupt Control Switch to stop filling during operation.
n115 Volt, 60 Cycle, 1 Phase Standard. 220 Volt, 60 Cycle,
1Phase optional. Supplied with Cord and Plug.
nCold Water connection only, 3⁄4˝potable cold water line
required.
nLarge Flow 3⁄4˝Stainless Steel Swing Spout fills kettles
quickly.
nFor wall mounted models, three 5⁄16˝diameter holes are
pre-punched from the factory to bolt against a wall.
Options & Accessories
pModel SWM Stand for GMF and LMF models.
*For Console Mounted Models:
pRequires Console Mounting Option (CM)
pAvailable for all KEL and KDL floor model kettles,
MKEL and MKDL mixer kettles
pGMC1, LMC1 is not available on KGL or MKGL
series kettles
Shall be CLEVELAND, Model ___ M _____ Water Meter; 115 Volt, 60
Cycle, 1 Phase; Supplied with Cordand Plug; all type 304 Stainless Steel
exterior construction; Power On/OffSwitch; Water Resistant Controls and
Switches; Adjustable Volume Setting Indicator; Digital LED Readout; Start
Switch with Reset and Continue Mode operation; Large Flow 3⁄4˝Stainless
Steel Swing Spout.
ShortFormSpecifications
SECT. XIII PAGE 1
0707
WATER METERS
AUTOMATIC WATER METER & DISPENSING SYSTEM
GMF, LMF SERIES
GMC1, LMC1 SERIES
Console Mounted Models:*
cMODEL GMC1 - U.S. GALLONS
cMODEL LMC1 - LITERS

SECT.XIII PAGE 2
0707
Litho in U.S.A.
NOTES:
Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Installation of backflow preventers, vacuum breakers and other specific coder requirements is the responsibility of the owner and installer.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are U.L., A.G.A., NSF, ASME/N.Bd., CSA, CGA, ETL and others.
HOSE BRKT
12.13”
(308mm)
17.38”
(441mm) 12.50”
(318mm)
9.63”
(24mm)
48.50”
(1232mm)
22.00”
(559mm)
41.5”
(105.4mm)
12.00”
(305mm)
DIA.
5.63”
(143mm)
10.00”
(254mm)
4.75”
(121mm)
9.50”
(241mm) 3/4” UNION
WATER INLET
48.00”
(122mm)
RECOMMENDED
OPTIONAL WALL MOUNT UNIT SHOWN
WITH OPTIONAL FILLER HOSE
STANDARD WATER METER SHOWN
ON OPTIONAL PEDESTAL MOUNT
1.88”
(48mm)
6’ - .75” O.D.
(183cm x 19mm O.D.)
OPTIONAL HOSE
.55” (14mm) DIA.
ON 10.75” (273mm) BCD.
LEVEL ADJUSTABLE
115V / 1PH
5’ (152cm) CORD
WALL
FLOOR
6.00”
(152mm)
STANDARD: 115V, 1PH, 60HZ
OPTIONAL: 208-240V, 1PH, 50/60HZ
ELECTRICAL RATINGS