PAGE: 2 OF 2
02
BULLETIN 1.0
MODEL
BRAKE HANDLE
REPLACEMENT 2.0
MODEL
6
Install the new Brake Handle onto the cable. Carefully
seat the cable end barrel into the handle using a small
cross screw driver.
CROSS
SCREW
DRIVER
7
Insert the new brake handle into the brake cylinder.
Push any excess cable back inside the cable housing.
8
Reinstall the two screws that hold the brake and brake
cylinder assembly to the bottom of the tray.
CROSS
SCREW
DRIVER
9
Push the cable bolt with one (1) washer into the brake
hammer with the washer between the cable and
plastic. Then install the second washer and lock nut
on the opposite side of the brake hammer.
10
Tighten the cable lock nut while holding the brake
hammer in the approximate position shown.
10MM
SOCKET
DRIVER
11
Adjust the brake cable until the brake hammer fully
engages the brake gear, as shown, when the brake is
in the ON position.
