CMA Dishmachines EAH Manual

TUBE
STIFFENER
AUTO START
SWITCH
DELIMER SWITCH
POWER SWITCH
CHEMICAL
TUBING
2" DRAIN
OUTLET
1/2" WATER
INLET
2
HARD WIRE
POWER SUPPLY
1
Models EAH, EC, EAH-T, EC-T
Quick Setup
Instructions
WARNING: Electrical and plumbing connections
need to be made by a licensed service person
and comply with all Federal, State and Local
Health, Electrical, Plumbing and Safety codes.
11-2016
Insert tube stiffener with chemical tubing
into each corresponding chemical
dispensers.
BLUE
RED WHITE
3
STEP
1
STEP
WALL
DRAIN
8"
FLOOR DRAIN
Connect a 2" drain pipe (not supplied)
from scrap accumulator to floor or
wall drain.
2
STEP
Connect dishmachine to hot water source
(minimum 120-140 temperature
required).
3
3
WHITE
BLUE
RED
PN: 10130.23
MODEL “E” REAR VIEW

000000
MODEL "E" FRONT VIEW
11-2016
WARNING: Electrical and
plumbing connections need to
be made by a licensed service
person and comply with all
Federal, State and Local
Health, Electrical, Plumbing
and Safety codes.
Models EAH, EC,
EAH-T, EC-T
Quick Setup
Instructions
Level dishmachine by adjusting leveling
legs. Dishmachine must be level front and
back to ensure proper performance.
4
STEP
Open dishmachine doors completely.
Closing the doors will automatically activate
the machine.
000000
START
6
STEP
Press and hold the Fill/Start Switch until
the water level is approximately 1/2" to 3/4"
below the overflow hole in the PVC
standpipe.
5
STEP
000000
FILL
POLY PRO
TM
SCRAP
ACCUMULATOR
DOOR HANDLE 6
FILL/START
SWITCH 5
CYCLE LIGHT
RINSE SWITCH
SANI/DETERGENT
SWITCH
The Spirit of Excellence
an Ali Group Company
PERISTALTIC
PUMP
LEVELING
LEGS
4
THERMOMETER NEEDS TO
BE INSTALLED:
The Models E-AH and C are
Shipped from CMA without
thermometer being installed. To
prevent leaking, the installation
Team will need to install it on the
dishwasher using TEFLON TAPE.
So the thermometer for this unit is
not misplaced during shipment,
please find thermometer shipped
inside the dishwasher, zip-tied
to the dishrack.