CMA Dishmachines L-1C Manual

1" DRAIN HOSE
CONNECTION
2
Model L-1C
Quick Setup
Instructions
WARNING: Electrical and plumbing
connections need to be made by a
licensed service person and comply
with all Federal, State and Local
Health, Electrical, Plumbing and
Safety codes.
5-2015
1
STEP
Connect dishmachine to hot water source
minimum 120°F required,
140°F temperature recommended.
Insert tube stiffener with chemical tubing
into each corresponding chemical
dispenser.
3
STEP
BLUE RED WHITE
Connect the drain hose to wall or floor drain.
The floor drain must have a 1-inch air gap
between drain hose and floor drain.
WALL DRAIN FLOOR DRAIN
1"AIR GAP
2
STEP
NOTE: DRAIN
HOSE NOT
SUPPLIED
BY CMA
3TUBE
STIFFENER
11/2" WATER
INLET
LEVELING LEGS
4
Level dishmachine by adjusting leveling legs.
Dishmachine must be level, front and back, to
ensure proper performance.
4
STEP
800-854-6417
R
DISHMACHINES
POWER
RINSE START
DETERGENT SANITIZER
PRIMERS
CYCLE DRAIN/ FILL
3CHEMICAL
TUBING
BLUE
RED WHITE

Model L-1C
Quick Setup Instructions
WARNING: Electrical and plumbing
connections need to be made by a
licensed service person and comply
with all Federal, State and Local
Health, Electrical, Plumbing and
Safety codes.
NOTE: WATER AND CHEMICALS
TO THIS DISHWASHER MUST BE
PROGRAMMED BY A QUALIFIED
CHEMICAL SPECIALIST.
5-2015
800-854-6417
5
STEP
Push power switch to “ON” power.
POWER
RINSE START
DETERGENT SANITIZER
PRIMERS
CYCLE DRAIN / FILL
DISHMACHINES
R
FILL
8
STEP
Close the door, then press start switch.
POWER
RINSE START
DETERGENT SANITIZER
PRIMERS
CYCLE DRAIN / FILL
DISHMACHINES
R
FILL
7
STEP
POWER
RINSE START
DETERGENT SANITIZER
PRIMERS
CYCLE DRAIN / FILL
DISHMACHINES
R
6
STEP
POWER
RINSE START
DETERGENT SANITIZER
PRIMERS
CYCLE DRAIN / FILL
DISHMACHINES
R
FILL
R
DISHMACHINES
POWER
RINSE STAR T
DETERGENT SANITIZER
PRIMERS
CYCLE DRAIN / FILL
TIMER
PERISTALTIC
PUMP
THERMOMETER
6SANITIZER
CYCLE LIGHT
POWER
5
DRAIN / FILL
7
START
8
DETERGENT
6
RINSE
6
Press and Hold down "SANI", "DETERGENT"and "RINSE"
switches to prime chemicals. This step must be repeated each
time chemical containers are changed.
FILL LINE
Hold down "FILL" Switch for approximately 10 - 15 seconds to allow water to flow into the dishwasher.
Water should reach “FILL LINE” which is located inside at the back of the wash tank. NOTE: The 4th cam
of timer assembly has to be adjusted to maintain the same water level during the cycle.
TO
OPERATE
MACHINE
SET DELIMER
SWITCH TO
NORMAL
FILL
HOT
NEUTRAL
GROUND
DO NOT USE POWER
CORD OR GFI OUTLET.