CNC Design D-500 User manual

CNC D-500 Vac Boot Instructions V1.0
http://www.ukcnc.net
Contents
Checklist........................................................................................................................................................2
Build Instructions ..........................................................................................................................................6

Checklist
http://www.ukcnc.net
Name
Dimensions
Quantity
Packing
Check
Customer
Check
Hose Adaptor
1
Small Brush
2
Large Brush
2

Name
Dimensions
Quantity
Packing
Check
Customer
Check
M4 x 8mm
24
M5 x 25mm
4
M6 x 20mm
4
32mm Hose
Clip
5
40mm Hose
Clip
5

DC-Plate 22
Quantity
1
Packing
Check
Customer
Check
DC-Plate 23
Quantity
1
Packing
Check
Customer
Check

DC-Plate 37
Quantity
1
Packing
Check
Customer
Check

Build Instructions
http://www.ukcnc.net

Bolt in the two small side brushes with M4 x 8mm screws.
Make sure magnets are facing upwards.
Bolt in the two side brushes with M4 x 8mm screws.

Slide the flange adapter over the rubber adapter.
Insert the M6 x 20mm screws to fasten the rubber adapter to the plate.
Make sure the magnets in the plate are facing down.

Make sure the spindle is tightened off in the spindle holder before
attaching the assembly.
Align the holes of the brush plate with spindle holder and tighten off
the M5 x 25mm screws.

The brush assembly can now be attached by lining up the magnets on
each plate.