CNC4PC C97-GECKO G250X User manual
USER’S
MANUAL
VER.1
C97 –GECKO G250X
MOTHERBOARD. Rev. 2
NOVEMBER 2022
User’s Manual Page i
USER'S MANUAL
TABLE OF CONTENTS
Contents Page #
0.0 OVERVIEW......................................................................................................................1
1.0 FEATURES......................................................................................................................1
2.0 BOARD DESCRIPTION ..................................................................................................2
3.1 DIPs Configurations...................................................................................................2
3.0 SPECIFICATIONS...........................................................................................................3
4.1 Power Requirements..................................................................................................3
4.0 ENABLE OUTPUT FOR DB25 CONNECTOR................................................................3
5.0 INPUT LIMIT SWITCH.....................................................................................................4
6.0 WIRING SAMPLE............................................................................................................5
7.0 DIMENSIONS ..................................................................................................................6
User’s Manual Page 1
0.0 OVERVIEW
This Motherboard is used for the Gecko G250X Rev.3
1.0 FEATURES
•DIP switch current setting, up to 3.5A peak.
•Support up to 4 Drivers.
•Pot for adjust trimpot.
•DB25 female Connector.
•Pluggable Screw-On Terminals.
•I/O Signals.
User’s Manual Page 2
2.0 BOARD DESCRIPTION
3.1 DIPs Configurations
User’s Manual Page 3
3.0 SPECIFICATIONS
4.1 Power Requirements.
It requires a 15-50VDC external power supply to operate.
WARNING
Check the polarity and voltage of the external power source and connect the 15-50VDC
and GND. Overvoltage or reverse-polarity power applied to these terminals can cause
damage to the board, and/or the power source.
4.0 ENABLE OUTPUT FOR DB25 CONNECTOR
User’s Manual Page 4
5.0 INPUT LIMIT SWITCH
User’s Manual Page 5
6.0 WIRING SAMPLE
Note: This wiring is just to illustrate a sample product application. Specific wiring may
vary from system to system. It is the user’s responsibility to implement it correctly.
User’s Manual Page 6
7.0 DIMENSIONS
All dimensions are in Millimeters.
Fixing holes (4mm)
DISCLAIMER
Use caution. CNC machines can be dangerous machines. Neither DUNCAN USA, LLC
nor Arturo Duncan are liable for any accidents resulting from the improper use of these
devices. This board is not a fail-safe device and it should not be used in life support
systems or in other devices where its failure or possible erratic operation could cause
property damage, bodily injury or loss of life.
Table of contents
Other CNC4PC Motherboard manuals
