Coleman Kraz X1 User manual

Connect Frame to Tent
– Insert one Pole Talon™ into pole on stake loop
located at middle edges of the tent.(illus. 3)
– Go to opposite end of pole and
gradually apply pressure to the
pole forming an arch until you
are able to insert the pole talon
into the pole.(illus. 3 & 4)
– Attach Frame Clip on each
side of tent. (illus. 5)
– Tie frame ties
around the tent pole.
Kraz
™
X
1
part number 2000000451
1
2
Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with doors facing
desired direction. (illus. 1)
– For best results in windy conditions position
end of tent into the wind.
– Stake down tent corners using the stake loops.
Keep the floor taut. Unzip doors. (illus. 2)
– Assemble Frame Poles by interlocking
shock-corded sections. This will make one long
and one short “U” shaped pole.
– Insert the longer pole through the pole sleeve
located in the middle of the tent and the shorter
pole into the sleeve at the foot of the tent. (illus. 1)
Main Tent Pole
Part No. 9830-1191
Foot Pole
Part No. 9830-1291
Rainfly
Part No. 9830-1391
illus. 1
Two side doors
Pole Sleeve
illus. 2
Tent stake
through Loop
illus.3
Insert Pole Tip
into grommet
illus.4
Tent completely set up and
staked out.
POLE ASSEMBLY PART
illus. 5
Frame Clips

Things You Should Know
• Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation
is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent
fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.
• Never store tent, even for a short period of time, without
drying it thoroughly and brushing off caked dirt. Do not pack
stakes or poles inside your tent. Use separate storage bag.
• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE
ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE
LOOP TO REMOVE STAKE.
• TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
3Attach Rainfly
– Layout the Rainfly and locate the logo
(illus.6)
– Drape Rainfly over tent frame, the logo
should be at the foot of the tent. (illus. 7)
– Connect the clips on the rainfly
(found at the Rainfly corners) to the stake
loops at the corners of the tent. (illus. 7 & 8)
– Stake out Rainfly at the front rear and
on each side of the zippered door/vestibule.
Pull stake loops out away from tent until
Rainfly is taut. (illus.7)
illus. 7
Completed tent
with Rainfly. Note
where Rainfly hooks attach
and where to stake out rainfly
illus. 8
Rainfly clips
to tent
stake loop
Rainfly stake loop
Rolls up and attaches
with toggle & loop for
easy access or added
ventilation
Two Rainfly stake loops
on each side
Printed In China Rev. 11/07
© 2000 The Coleman Company, Inc. All Rights Reserved.
illus. 6
Rainfly shown
with clips
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com