Coleman 9392-161 User manual

Pole Assembly
–You will need to assemble and connect one
pole at a time to the hub.
–Do not completely assemble poles.
a) Beginning at spring-clip end of pole,
assemble all but the last shock-corded
section. The pole and one section
should curve downward. (illus. 2)
b) Insert the spring-clip end into one of the
hub ports until it clicks into position.
(illus. 1), (illus. 2)
c. Repeat for each of the five remaining
poles (illus. 2)
16’x14’ Insta-Clip Screen House
1
When You Are Ready To Set Up Your
Shelter
–Select a level area clear of rocks,
branches and other hard or sharp objects.
–Do not set up your shelter under trees.
–For easier set up, two or more people
are recommended.
–Place fabric in center of selected location
and assemble above fabric.
ASSEMBLY PARTS
Instructions apply to Part Number 9392-161
Poles (6) Part No. 9392-2291
Hub (1) Part No. 9392-2351
Illus. 2
Screen House laid out in position
with partially assembled frame
locked into hub.
Illus. 1
Poles inserted
into hub
Hub
Hub
Insta-Clips

2
3
PRINTED IN SRI LANKA Rev. 11/04
Things You Should Know
• Never store shelter, even for a short period of time, without drying it thoroughly and
brushing off caked dirt. Do not pack stakes or poles inside your shelter. Use
separate storage bag.
• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER
PULL ON THE SHELTER FABRIC OR STAKE LOOP TO REMOVE STAKE.
• SHELTER POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
• Do not leave your shelter set-up for weeks at a time, be aware that exposure to the
ultraviolet rays of the sun can seriously damage material and/or cause it to become
discolored.
WARNING: Keep all flame and heat sources away from this shelter fabric.
This shelter meets the flammability requirements of CPAI-84. The fabric will burn if
left in continuous contact with any flame source. The application of any foreign
substance to the shelter fabric may render the flame-resistant properties ineffective.
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN SRI LANKA
Attach Shelter to Frame
–With the frame still partially set up, clip
the center of the Screen House to the
center hub. (illus. 3)
–Starting towards the center of the
Screen House, clip the shelter fabric to
the poles.
Complete Shelter
–Fully extend each pole by straightening
all shock-corded pole sections.
–Insert the pin on the pin and ring
system, at the corner of the Screen
House into the the pole end.
(illus. 4), (illus. 6)
–Repeat for remaining poles.
–Adjust poles to pull the shelter
taut and stake down through
the fabric loops at the end of
pin and ring. (illus. 5), (illus. 6)
–Attach guy lines to fabric
guy loops at each corner
and stake out (illus. 6)
illus. 3 Screen House clipped to
partially assembled frame
Start by attaching the
center of the Screen
House to the pole hub.
illus. 4
Insert into the
pole end
illus. 6
Completed shelter with
guy lines staked out
illus. 5
Stake through
stake loop