Coleman EVANSTON 4 User manual

STITCH LINE
EVANSTONTM 4MODEL 2000001586
To Set Up Tent
1. Unfold tent and spread out on a clean, level surface with
the door facing the desired direction. (Fig. 1)
2. Assemble all poles by interlocking the shock-corded,
sections together.
3. Insert black Main Poles through the black trimmed
sleeves on top of tent forming an X”.
4. Insert grey Main Pole through grey trimmed sleeve, in
front of tent. Make sure grey Main Poles overlap the
black Main Poles. (Fig. 1)
5. Insert end of each black Main Pole into pins located in the
corners of the tent. (Fig. 2 & 2A)
6. Go to opposite end of each black Main Pole and gradually
apply pressure to each forming arches. Insert the pin into
each pole end at the corners of tent. (Fig. 2 & 2A)
7. Insert end of the grey Main Pole into pin located on
the sides of the tent. (Fig. 2 & 2B)
8. Go to opposite end of the grey Main Pole and
gradually apply pressure to form an arch. Insert
the pin into pole end at the side of tent. (Fig. 2 & 2B)
9. Attach frame clips along edges of tent to the black
& grey Main Poles. (Fig. 2C)
10. Stretch tent until taut, then secure metal loops
located on both sides and four corners of tent
with stakes. (Fig. 2D)
To Attach Rainfly
1. Drape Rainfly over tent with green vestibule flaps locat-
ed at the front of the tent. (Fig 3).
NOTE: Hook and loop fasteners, located on seams of
underside of Rainfly, should be centered over black &
grey Main Poles.
2. Insert black Rainfly Pole with through sleeve in
underside of Rainfly above front door of tent. (Fig. 3)
(continued on other side)
Fig. 2
2C
Door
2D
Fig. 1
Door
Front of Tent
Grey, Shock-corded
Main Pole
Black, Shock-corded Main Poles
Sleeves with Black Trim
Sleeve with
Grey Trim
2A
Fig. 3
Black Rainfly
Pole
Door
Rainfly Sleeve
Pole Descriptions
Pole Pole Pole
Description Qty. Dia. Repair Kit Replacement Kit
Main Pole, black 2 9.5mm 5010000540 5010000548
Main Pole, grey 1 9.5mm 5010000540 5010000548
Rainfly Pole, black 1 9.5mm 5010000540 5010000548
Awning Pole, black, short 1 6.3mm 5010000543 5010000545
2B
Front of Tent
Fig. 4
Awning Pole
Rainfly Sleeve
Front of Tent
Back
of Tent
3. Insert short, black, thin Awning Pole through sleeve
in underside of Rainfly above window at back of tent.
(Fig. 4)
4. Insert metal tip into grommet on tent seam at back of
tent (Fig. 4A). Go to opposite end of Awning Pole and
gradually apply pressure to pole forming an arch; then
insert metal tip into grommet.
Vestibule Flap
Vestibule Flap
Rainfly
Approximate
Grommet
location
on tent
Approximate
Grommet
location
on tent
4A
Awning
Pole
Grommet
Before you begin
Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees because of potential
lightning strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent
property damage or personal injury.
• For best results in windy conditions, position narrow end of
tent into the wind.
• Enlist the help of at least one other person to assist you when
it is time to assemble the tent.
All manuals and user guides at all-guides.com
all-guides.com

STITCH LINE
To Store
1. All poles and stakes must be placed in the storage bag to
prevent damage to the fabric items placed in the carry case.
2. Make sure tent is clean and dry before placing in carry case.
3. Remove rainfly, spread out on floor of tent, then unzip
door & vents before taking tent down for storage.
4. Neatly fold tent to width of pole storage bag, place on tent,
roll tightly, and place in carry case.
5. Store in a clean, dry area.
Electrical Cord Access
1. Unzip access panel in the lower
left front corner of tent and
bring in electrical cord. Use only
UL approved cords that are
rated for outdoor usage. (Fig. 9)
Fig. 9
To Attach Rainfly continued
5. Insert end of each black Rainfly Pole into pin on either side of front door. (Fig. 5 & 5A)
6. Go to opposite end of Rainfly Pole and gradually apply pressure to form an arch. Insert the pin into pole end at other side of the
door. (Fig. 5 & 5A)
7. Locate all hook & loop fasteners on underside of Rainfly and wrap around all Main Poles, Awning & Rainfly Pole to secure. (Fig. 5B)
NOTE: Make sure longer hook & loop fastener on Rainfly is secured around grey and black Main Poles where they cross. (Fig. 5C)
8. Stretch elastic straps and hook clip on each to the metal loops at the front and back corners of the tent. (Fig. 5D)
9. Extend out vestibule flaps and secure with metal stakes through the loops in the web straps (Fig. 5 & 5E)
10. Stretch guylines until taut, then secure with stakes. (Fig. 5 & 5F)
Vestibule Flaps, Door & Window Flaps/Vents
1. Vestibule flaps may be rolled back and
secured by inserting toggles through
fabric loops. (Fig. 6)
2. For better ventilation, unzip door flap,
roll, and insert toggle into fabric loop
to secure. (Fig. 7)
3. To open back and side window
vents for more ventilation, unzip,
then roll up and insert toggles through
fabric loops.
The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA • PRINTED IN CHINA
© 2008 The Coleman Company, Inc.
Coleman®, , and are registered trademarks and EvanstonTM is a trademark of
The Coleman Company, Inc.
4010003993 (20081114)
Fig. 6
Cooler Access
The smaller zippered opening at the back
of tent is designed for added ventilation
and easy access to your beverage cooler.
1. To use as a vent, unzip flap to expose
screen. (Fig. 10)
2. To use as a cooler access, unzip
other flap to make an avenue to bring
beverages into tent. (Fig. 11)
Fig. 11
Fig. 10
Fig. 5
5B
5E
5F
5A
5C
5D
Fig. 8 Fig. 7
Things You Should Know:
• Under certain conditions (cold weather, high humidity, etc.) condensa-
tion will form on the inside of your tent. Condensation is caused by water
vapor from your breath, perspiration, or any wet clothing inside the tent.
It is NOT LEAKAGE through the tent fabric. It can be minimized by
removing wet clothing from your tent and by providing good ventila-
tion through the tent.
• Tree limbs, tree sap, bird droppings, or moisture steadily dripping off
tree limbs can cause damage to the tent fabric and its coating resulting
in leaks or loss of flame-resistant properties.
• Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your tent. Use a separate storage bag.
• Stakes should be removed by pulling on the stake itself. NEVER PULL ON
THE TENT TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
• Tent poles should not be left telescoped together during storage.
• Do not leave your tent set-up for weeks at a time. Be aware that exposure
to ultraviolet rays from the sun can seriously damage material and/or
cause it to become discolored.
WARNING: Keep all flame and heat sources away
from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
All manuals and user guides at all-guides.com