3Raise Center of Tent
– Assemble center shock-corded brace poles
(red sticker, longer poles). Pole should be
initially adjusted to the inner most hole “A”.
(illus. 7)
– Insert square end of brace poles into
curved roof poles and raise tent upright.
(illus. 5, 6, 7)
– Brace poles should attach to squeeze
pins at bottom of tent. (illus. 8)
illus. 5
Shown with both
center brace poles
in position and
curved poles
through both
center pole
sleeves.
Center brace pole
Rainfly
4
illus. 6 When attaching the brace poles
to the curved poles make sure that the
brace poles naturally point straight down.
illus. 9 Tent shown completely set-up.
Raise Sides of Tent
– Assemble end (blue sticker, round
ends) shock-corded brace poles.
– Insert (blue sticker) brace poles into
end roof assemblies. MAKE SURE
when attaching the brace poles to the
curved poles that the bottom of the
brace pole naturally points down and
toward the center of the tent. (illus. 9)
– Brace poles should attach to squeeze
pins at bottom of tent. (illus. 8)
– Can be adjusted to accommodate
for terrain
– Drape rainfly over tent and attach
“S” hooks on rainfly into holes in
brace poles. (illus. 9)
Brace pole
Curved
poles in pole
sleeve
Brace pole
with hole
for rainfly
“S” hooks
illus. 8
Insert squeeze
pin into pole
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN SRI LANKA
PRINTED IN SRI LANKA Rev. 7/04
Things You Should Know
• Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is caused by
water vapor from your breath, perspiration, or any wet clothing inside your tent. It is
NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing
from your tent and by providing good ventilation through the tent.
• Never store tent, even for a short period of time, without drying it thoroughly and
brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate
storage bag.
• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER
PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.
• TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
• Seam sealer has not been provided with your tent. For additional protection we
recommend seam sealing your tent prior to camping. Seam sealer may be purchased
through your local retailer or at your local sporting goods store.
• Do not leave your tent set-up for weeks at a time, be aware that exposure to
the ultraviolet rays of the sun can seriously damage material and/or cause it to
become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM
THIS TENT FABRIC. This tent meets the flammability requirements
of CPAI-84. The fabric will burn if left in continuous contact with any
flame source. The application of any foreign substance to the tent
fabric may render the flame-resistant properties ineffective.
Poles should be
initially adjusted to the
inner most hole “A”.
illus. 7
