Coleman Monterey 9272-162 User manual

Connect Frame to Tent
–Insert the pin into the end of the black main
tent pole at the rear of the tent.
(illus. 3, illus. 4)
–Go to opposite end of pole and gradually
apply pressure to the pole forming an arch
until you are able to insert the pin into the
pole end. (works best standing in the door,
with two people) Repeat for second pole.
–Insert the pin on the side into the side pole
end. Go to opposite end of pole and
gradually apply pressure to the pole forming
an arch until you are able to insert the pin
into the pole end. (illus. 3, illus. 4)
Monterey™16’x12’
1Layout & Positioning of Tent,
Pole Assembly
–Layout and position tent with door
facing desired direction. (illus. 1)
–Unzip door.
–Stake down tent, using the rings on the
stake loops. Keep the floor taut. (illus. 2)
–Assemble frame poles by interlocking
shock-corded poles. (three poles)
–Insert the main tent poles through the two
pole sleeves with black trim. The poles
will cross in center of the tent.(illus. 1)
–Insert gray side pole through the pole
sleeves running parallel to the door.
This will go from side to side.
2
When You Are Ready To Set
Up Your Tent
–Select a level campsite clear of
rocks, branches and other hard or
sharp objects.
–Do not set up your tent under trees.
–For best results in windy conditions,
position the end of tent into the wind.
Front Rainfly Pole
Back Rainfly Pole
Front Door
Black Main Poles
through pole sleeves
Gray Side Pole
through pole sleeves
Instructions apply to Part Number 9272-162
illus. 1
illus. 2
Tent stake
through ring
on stake loop
illus. 4
Tent frame
set-up
Part No. 9272-302
Part No. 9272-306
Part No. 9272-308
Part No. 9272-304
(Black) Main Tent
Poles
(Gray) Side Pole
illus.3
Insert pin into pole end
Rainfly Part No. 9272-310
Side Pole

THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA
PRINTED IN CHINA Rev. 11/04
Things You Should Know
• Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.
• Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your tent. Use a separate storage bag.
• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
• TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
• Seam sealer has not been provided with your tent. For additional
protection we recommend seam sealing your tent prior to camping. Seam
sealer may be purchased through your local retailer or at your local sporting
goods store.
• Do not leave your tent set-up for weeks at a time, be aware that expo-
sure to the ultraviolet rays of the sun can seriously damage material and/or
cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flammability
requirements of CPAI-84. The fabric will burn if left in continuous con-
tact with any flame source. The application of any foreign substance to
the tent fabric may render the flame-resistant properties ineffective.
Attach Tent to Frame
Using Frame Clips
–Attach frame clips along
the edges of tent to frame
poles. (illus. 5), (illus. 6)
–Make any adjustments to
the tent corner stakes that
are needed.
3
4Attach Rainfly
–Assemble rainfly poles by
interlocking shock-corded poles.
–Insert the longer rainfly pole through
pole sleeve at the front center of the
curved edges of the underside of
rainfly. The shorter pole goes in
back. (illus. 7), (illus. 9)
–Drape rainfly over tent frame, pole
side down. The longer rainfly pole
should be over the door and the
shorter pole over the rear window.
–Connect the six elastic loops
with hooks, (found at the rainfly
corners) to the six fabric loops on
the bottom row of frame clips.
(illus. 8), (illus. 9)
–Insert the tips of the rainfly poles
into the grommets on the pole
sleeve webbing. (See above illus. 6)
–Secure rainfly with attachments
located on underside of fly. (illus. 9)
–Attach and stake out guylines.
(illus. 9)
illus. 6
Assembled tent without rainfly.
NOTE:
Grommets
for rainfly
pole are on
frame clip
webbing illus. 5
Frame clips
illus. 7 Insert rainfly
poles through the
2 pole sleeves on
underside of rainfly
illus. 9
Completed tent with rainfly.
illus. 8
Underside of
rainfly attaches
to frame poles
Rainfly pole in
grommet
Guylines
Rainfly hooks attach to fabric loops
on the corner frame clips (illus. 8)
Rainfly pole
through
pole sleeves
Hooks attaches
to fabric loop