Colop digital e-mark create User manual

1
Remove top cover.
Insert ink cartridge.Remove protective film from printhead.
Turn on device and print test image. Install App: getemarkcreateapp.colop.com
Remove battery & pull out tab (first use only).
Re-insert battery and close top cover.
8
7
2
9
Open bottom latch by pinching
& sliding forwards & downwards.
1
2
3
Close bottom latch.
Enter SSID & password, found hereConnect via WIFI. Optional for iOS Devices.
10
Place on docking station & plug in to charge.
1211
For complete instructions visit:
emarkcreate.colop.com/support
QUICK SET UP GUIDE CORRECT INCORRECT
456

1. In the app select New Imprint from the drop
down menu.
2. Choose Start Without Template or select
a pre-made template from your preferred
category.
3. Arrange or edit your artwork on the canvas.
4. Once your design is ready to go select the
e-mark® create icon in the top right corner.
5. The e-mark® create will beep & the app will
indicate when your print has been received.
6. Simply swipe e-mark® create to print your design.
PRINTING AT A GLANCE
MULTILINE PRINTING CONTINUAL PRINTING AUTOMATIC CLEANING CYCLE
MENU GUIDE
1. Print your design
2. Connect your e-mark® create check battery
& ink levels
3. Choose a customizable template or design
your own.
4. View, edit or print a previous design.
5. Updated preferences, clean print head, &
more.
6. Web instructions, order ink cartridges, & more
1. Choose between single line or multi-line
canvas.
2. Adjust the width of your canvas.
3. Turn continual printing on or o.
B
B
A
A
C
C
D
E
B
C
D
E
F
F
IMPRINT SETTINGS
B
A
C
B
A
C
1. Choose either two or three line printing option.
2. Once your design is ready to go select the
e-mark® create icon in the top right corner.
3. The e-mark® create will beep & the app will
indicate when your print has been received.
4. Follow the chart above to print each line. The
e-mark® create will beep to indicate when you
should change direction.
1. Make sure continual marking is turned on in
imprint settings.
2. Once your design is ready to go select the
e-mark® create icon in the top right corner.
3. The e-mark® create will beep & the app will
indicate when your print has been received.
4. Swipe e-mark® create to print your design. The
e-mark® create will continue to print as long as
it is in motion.
1. Take e-mark® create from docking station.
2. Hold briefly in the air (wait for ink to disperse).
3. Put on Paper & print.
The e-mark® create cleans its print head automatically
whenever it is taken from the docking station. The
intensity of cleaning increases the longer the e-mark®
create is not used.
Do not point towards the eyes, face, or skin. Do not
point towards docking station or towards the print
surface during the cleaning cycle.
LIGHT GUIDE
Continuous Green Light
On, not connected via WIFI.
Continuous Green & Blue Lights
On & connected to WIFI
Continuous Green Lights
Plugged in and fully charged.
Flashing Yellow Light
Charging, battery is charged between
0-49%.
Flashing Green Light
Charging, battery is charged above 49%.
Flashing Red Lights
Return e-mark create® to the docking
station.
TIPS & TRICKS
A