
Please Note: When wirelessly charging a device, the wireless
charger and your device may feel warm. This is a normal
operating condition and should not be cause for concern.
Made in Chinawww.comsol.com.au
iPhone is a trademark of Apple inc.,
registered in the U.S. and other countries.
The ‘Qi’ Symbol is a trademark of the
Wireless Power Consortium.
Important Safety Instructions
• Only use original or reputable third party chargers and cables
• Only use the product for the specified purpose of use
• Do not get wet to avoid causing short circuit damage and leakage
• Do not use in extreme hot, humid or corrosive environments to avoid
short circuit damage and leakage
• Do not place too close to magnetic strip or chip ID card to avoid
magnetic failure
• Do not place within 20cm of implantable medical devices (pacemaker,
cochlear implant etc.) to avoid potential interference
• Do not clean with harmful chemicals or detergents
• Misuse, dropping or excessive force may cause damage to the charging
dock
• Do not use the product if it is damaged or emits a suspicious odour
• Unplug the product from power sources when not in use
Troubleshooting
• If your wireless charging does not work then please adjust
the feet of the cradle upwards or downwards. The wireless
charging coil in your phone needs to match the position of
the wireless charging coil in the charger. Slide the feet up and
down whilst the phone is sat in the cradle and the power is
connected until your two coils line up and charging
commences