CSAT-5060 C-Band Satellite Transceivers Revision 1
Table of Contents MN/CSAT5060.IOM
iv
2.1 Dimensional Envelope .......................................................................................................................2-1
2.2 Specifications......................................................................................................................................2-7
CHAPTER 3.CONNECTOR PINOUTS.................................................................................3–1
3.1 Pin-outs..............................................................................................................................................3–1
3.1.1 Connector J3: AC Power, Mains, 100 to 125 VAC, or 205 to 240 VAC. ..................................3–1
3.1.2 Connector J5: COMM, Remote communications port ................................................................3–2
CHAPTER 4.SYSTEM OPERATION....................................................................................4–1
4.1 Turning On the CSAT......................................................................................................................4–1
4.2 Configuring the CSAT......................................................................................................................4–1
4.2.1 Frequency.....................................................................................................................................4–1
4.2.2 Attenuation...................................................................................................................................4–2
4.2.3 Gain Offset...................................................................................................................................4–2
4.2.4 Mute Mode...................................................................................................................................4–2
4.2.5 Mute.............................................................................................................................................4–3
4.2.6 Tx Amplifier ................................................................................................................................4–3
4.2.7 Channel Slope Adjust Mode ........................................................................................................4–3
4.2.8 Channel Slope Adjust...................................................................................................................4–4
4.2.9 Reference Frequency Adjust........................................................................................................4–4
4.2.10 External Reference Fault Logic .................................................................................................4–4
4.2.11 Cold Start Function....................................................................................................................4–5
4.2.12 Auto Fault Recovery..................................................................................................................4–5
4.2.13 LNA Current Source..................................................................................................................4–6
4.2.14 LNA Current Calibration and Current Window.........................................................................4–6
4.2.15 LNA Fault Logic........................................................................................................................4–6
4.2.16 Redundancy Controller Auto/Manual........................................................................................4–7
4.2.17 Redundancy Controller Toggle..................................................................................................4–7
4.2.18 Set Physical Address..................................................................................................................4–7
4.2.19 Set Baud Rate.............................................................................................................................4–8
4.2.20 Set Date......................................................................................................................................4–8
4.2.21 Set Time.....................................................................................................................................4–8
CHAPTER 5.REDUNDANT SYSTEMS................................................................................5–1
5.1 Redundant System............................................................................................................................5–1
5.1.1 RSU-5060 Interfaces....................................................................................................................5–2
5.1.1.1 Electrical Interface............................................................................................................................................5–2
5.1.1.2 CSAT Unit A Interface, J1..............................................................................................................................5–2
5.1.1.3 Rx Waveguide Switch interface, J2...............................................................................................................5–3
5.1.1.4 CSAT Unit B Interface, J3..............................................................................................................................5–3
5.1.1.5 Tx Waveguide Switch interface, J4...............................................................................................................5–4
5.1.1.6 M&C Interface, J5............................................................................................................................................5–4
5.1.1.7 Tx IF Interfaces, J6, J7, and J8......................................................................................................................5–5
5.1.1.8 Rx IF Interfaces, J9 – J11................................................................................................................................5–5
