Conair LT8651CSC User manual

TOTAL BIKINI TRIMMING & STYLING SYSTEM
MODEL LT8651CSC
MINI SHAVER HEAD
WITH SINGLE FOIL
3 INTERCHANGEABLE
HEADS
Precision
trimmer head
ULTRA NARROW
TRAMLINER
Power handle
On/Off switch
Charging
indicator light

Fig 1
Fig 3
Fig 2

TOTAL BIKINI TRIMMING & STYLING SYSTEM
Conair® Total Bikini Trimming & Styling System gives you neat and gentle shaping, styling
and trimming of the bikini area. Its three interchangeable heads are specially designed to
give you the ultimate in choice, whatever your style.
Features:
• Rechargeable power handle.
• 3 interchangeable heads:
- Mini shaver head with single foil.
- Precision trimmer head.
- Ultra narrow tramliner head.
• 2 comb guides for use with precision trimmer head (Grades 1-10).
• Cordless.
• Cleaning brush.
• 2 x design stencils.
• Charging adaptor.
Now please read on to get fully acquainted with this new appliance before you begin.
OPERATION
CHARGING THE APPLIANCE
IMPORTANT! Only use the charging adaptor supplied with this appliance.
• Ensure the appliance is switched off.
• Connect the adaptor to the base of the power handle and plug the adaptor into the
mains.
• The charging indicator light located on the power handle will illuminate to indicate that
the appliance is plugged in.
• When charging for the first time, or when the appliance has not been used for a
considerable time, the appliance must be continually charged for 16 hours. This
will provide a minimum of 30 minutes use.
• Once the appliance is charged, unplug the adaptor from the mains and disconnect from
the power handle.
• The appliance is now ready for use.

CHANGING THE HEADS
Before changing heads, ensure the appliance is switched off, and unplugged. To remove the
head, twist the head in an anti-clockwise direction and pull away from the power handle
(see fig.1). NOTE: Never hold the shaver head by the foil. To replace the head, position it
by aligning the lugs on the head with the grooves on the power handle. Turn in a clockwise
direction until the head snaps into place (see fig.2).
MINI SHAVER
The mini shaver with single narrow foil shaves beautifully smooth. The superfine foil comes
with smaller holes and hypoallergenic gold coating, specially designed for sensitive skin to
deliver a super close shave.
Preparation for Use
• Always inspect the shaving foil for signs of damage. Never shave with a damaged foil as
this may result in injury.
• Do not use any oils, lotions or creams before using the shaver.
IMPORTANT Conair® Total Bikini Trimming & Styling System is designed specially for
shaping and trimming the bikini area, however, care must be taken not to apply too much
pressure during use to avoid injury.
Shaving:
For best performance:
• Ensure the power handle is sufficiently charged.
• First eliminate the longer hair using the precision trimmer head.
• Attach the shaver head as described in the section “CHANGING THE HEADS”.
• Switch the appliance on.
• Carefully hold the shaver head against the skin and for best results move gently against
the direction of the hair.
• For greater efficiency, stretch the skin ahead of the shaver with your free hand.
Do not apply too much pressure to avoid causing skin irritation or premature foil wear.
• Your skin may be very sensitive after use. Test your moisturizer on a small patch of skin
after shaving for signs of any irritation.

CLEANING AND MAINTENANCE:
After each use clean the shaving head as follows:
• Switch the appliance off.
• Remove the shaver head from the power handle.
• Remove the foil head from the shaving head (depress the two buttons on either side
of the shaving head and pull the foil head away).
• Using the cleaning brush, gently brush and blow any hairs from the cutter and shaving
head. Never use the brush on the shaving foil as this may cause damage.
IMPORTANT! Do not allow the power handle to come into contact with water or other
liquids.
PRECISION TRIMMER HEAD
The precision trimmer is designed for accurate shaping and comes with 2 guides and a
choice of 10 lengths for trimming.
PREPARATION FOR USE:
• Always inspect the appliance to ensure the precision trimmer head is free from hair etc.
and running smoothly. Check also for signs of damage and that the tips of the two blades
are parallel. Failure to do this can result in injury.
• Do not use any oils, lotions, creams before using the trimmer.
TRIMMING:
For best performance:
• Ensure the power handle is sufficiently charged.
• Attach the precision trimmer head as described in the section “CHANGING THE
HEADS”.
• Attach the appropriate comb guide. To attach the comb guide make sure that the appli-
ance is switched off, put the comb guide over the blades of the trimmer and push down
on the lip at the back of the comb guide until it clicks into place (see fig. 3).
• This will give you the shortest grade for the comb guide. For longer grades place thumb
on the switch located on the top of the comb guide and push forward.
• To remove the comb guide, ensure that the appliance is switched off. Lift the lip at the
back of the comb guide upwards and away from the trimmer head.
• We advise that you start trimming using the longest comb guide. Moving onto shorter
guides as required.
• Switch the appliance on.
• Gently trim the hair against the direction of the hair growth.

Shaping:
• For more detailed trimming and shaping and for a totally smooth finish remove the comb
guide from the trimmer head and very carefully trim the desired area, using light pressure
only.
• You may want to use the foil on the shaver head for an even smoother finish.
• Switch the appliance off after use, clean and store away.
• Never switch the trimmer off while in the hair.
CLEANING AND MAINTENANCE:
After each use, clean the head as follows:
• Switch the appliance off.
• Remove the head from the power handle.
• Comb guides may be rinsed under running water. Dry thoroughly before storing away.
• Using the cleaning brush, gently brush and blow any hairs from the blades and head.
Do not disassemble the blades for cleaning.
NOTE: Do not attempt to repair or replace the blades. In the event that the blades become
blunt or damaged, contact an authorized Conair Service Centre.
ULTRA NARROW TRAMLINER
The ultra narrow tramliner can be used for styling and design to give you the ultimate in
choice, whatever your style.
PREPARATION FOR USE:
• Always inspect the appliance to ensure the tramliner is free from hair etc. and running
smoothly. Check also for signs of damage and that the tips of the two blades are parallel.
Failure to do this can result in injury.
• Do not use any oils, lotions, creams before using the tramliner.
For best performance
• Ensure the appliance is sufficiently charged.
• The tramliner can either be used on its own to outline, create designs, or with stencils.

Design:
For use with stencils
• Use the precision trimmer and comb guide to trim hair to length.
• Hold the stencil flat against the skin.
• Use the tramliner to outline the stencil shape.
• Hold the tramliner flat against the skin.
• Move the tramliner upwards through the hair a little at a time to outline the desired shape.
• The tramliner will work most efficiently when cutting through the hair at its own speed.
Never force the tramliner.
• Never switch the tramliner off while in the hair.
• Remove the stencil.
• Use the precision trimmer without comb guide to remove the hair from the outside towards
the outline.
• Use the mini shaver for a smooth finish.
CLEANING AND MAINTENANCE:
After each use, clean the head as follows:
• Switch the appliance off and unplug if necessary.
• Remove the head from the power handle.
• Using the cleaning brush, gently brush and blow any hairs from the blades and head. Do
not disassemble the blades for cleaning.
NOTE: Do not attempt to repair or replace the blades. In the event that the blades become
blunt or damaged, contact an authorized Conair Service Centre.
NICKEL-CADMIUM BATTERIES
This appliance contains Nickel-Cadmium batteries. To protect the environment, the appliance
must be disposed of safely at the end of its life. Please take to a recycling centre for safe
disposal.
SAFETY CAUTIONS
• WARNING! Polythene bags over the product or packaging may be dangerous. To avoid
danger of suffocation, keep away from babies and children. These bags are not toys.
• WARNING! Do not use this appliance near water contained in sinks, bathtubs or other
vessels.
• Do not immerse the appliance in water or other liquids.
• Always remove the shaver head from the power handle before rinsing and allow to fully
dry before re-use. Do not bring the power handle into contact with water or other liquids.
• This appliance should only be used as described within this instruction book.
Please retain for reference.

• Always inspect the appliance before use for noticeable signs of damage. Do not use if
damaged, or if the appliance has been dropped. Do not use the appliance if the cord is
damaaged. In the event of damage, return the appliance to an authorized Conair Service
Centre for examination and repair.
• Only use the mains adaptor and attachments supplied with this appliance.
• Do not connect the adaptor to the mains with wet hands.
• Always unplug the appliance when fully charged.
• Do not leave the appliance unattended when switched on.
• Do not place the appliance on any surface while in operation.
• Careful adult supervision is required when the appliance is used on or near children or
some disabled persons. Do not use on young children.
• This appliance is not for use by children. Keep out of the reach of children.
• Special care is required when using the appliance close to sensitive areas. Use gentle
pressure only.
• Always switch off and unplug the appliance when changing heads, when cleaning or
when not in use.
• Allow appliance to cool before storing away.
• After use, do not coil the cord around the appliance as this may cause damage. Instead,
coil loosely by the side of the appliance.

LIMITED THREE YEAR WARRANTY
Conair will repair or replace, at our option, your appliance free of charge for
36 months from the date of purchase if the appliance is defective in workmanship
or materials.
To obtain service under this warranty, return the defective product to the service
centre listed below together with your sales slip and $5.00 for postage and handling.
In the absence of a receipt, the warranty period shall be 36 months from the date
of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES,
INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL
BE LIMITED IN DURATION TO THE 36 MONTH DURATION OF THIS
WARRANTY.
IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL,
OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER
WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER.
This warranty gives you specific legal rights, and you may also have other rights
which vary from province to province.
IB-7368
SERVICE CENTRE:
Conair Consumer Products Inc.
100 Conair Parkway,
Woodbridge, Ontario, L4H 0L2.
1-800-472-7606
©2007 Conair Consumer Products Inc.
www.conaircanada.ca
Consumer Call Centre E-mail :
[e-mail]
06CN1448