Concourse Vogue User manual

!
!
Operating*Instructions**

!
Preparing the Buggy for Play
Step 1: Open box and lift out buggy using handle as per image below
Step 2:Locate the two axles provided as per image below.

!
Step 3:Hold the red ‘push’ button down and fit axle into the section of
the frame in the direction of the yellow arrow as indicated in image below
Please Note - you will need to repeat this on both sides
Step 3 Continued: This is how the axles and buggy should look when
locked into place. Refer images below

!
Step 4:Remove Smart Wheels from carry case in preparation to fit to
the buggy.
Step 5:Slide Smart Wheels onto buggy axles and repeat on opposite
side as per images below
Please Note – Before fitting Smart Wheels you should refer to the Smart
Wheels Operating Instructions for detailed fitting procedures.

!
Step 6: Unlock lower section of the buggy as indicated by the yellow
arrow in image below
Step 7: Pull front wheel outwards to allow extension of the lower section
of frame

!
Step 7 Continued: Once lower section of frame is extended fully, lock
red lever as per image below

!
Step 8: Unlock centre section of frame and lift centre section of frame
until fully extended and lock red lever as per images below

!
Step 9: Unlock Top Handle red lever as per images below
Step 9 continued:Pull handle upwards and lock red lever into desired
position as per image below

!
Step 10: Adjust handle height to suit your preference as per images
below
Please Note – Ensure upper handle red lock lever is locked firmly after
any height adjustments are made
Step 11: Slide Fourth Wheel (A) into the buggy (B) as per image below

!
Step 11 continued: