CONSET R144120 User manual

MOUNTING INSTRUCTIONS
REPLACE CONTROL PANEL Skjern 2020-09-02
IMPORTANT
Make sure to unplug the table before starting this operation
This manual is for two different versions of the 501-11, the old 6 core wire and
the new 4 core wire one
1.) Remove power cord 2.) Make sure the table is unplugged!
230VAC!!
Cut the control panel wire 30cm from
table top edge
3.)Put the wire into the box and strip the ends of the wires and check if it
has 4 or 6 cores
ConSet A/S▪Industrivej 23▪6900 Skjern▪Denmark▪Phone [phone]▪[email protected] Page 1
R144120

6 core wire - old version
Use the single screw terminal to connect the green with the brown cable from
the table.
Connect the other wires with the screw terminal of the control panel:
Wire from desk frame Wire from panel
Black Yellow
Red White
Blue Red
Yellow Black
Green
Brown
4 core wire - New version
Connect the for wires that matches the colors as given in the table below:
Wire from desk frame Wire from panel
Yellow Yellow
White White
Red Red
Black Black
5) Close the box and screw it on the bottom side of the table top.
ConSet A/S▪Industrivej 23▪6900 Skjern▪Denmark▪Phone [phone]▪[email protected] Page 2