CONSET SQ147250 User manual

349750.0
Assembly instruction
EN
Page 2
SQ147250 - SQ147280
This instruction is a supplement to chapter
7 and 8 in the instruction, which is packed
together with the legset

2
7. PARTS
1a 1b 1c
2
5
3
4
6
7
8
J) x4
L) x1
M) x2
F) x6
G) x4
E) x10
DO NOT CONNECT TO
POWER BEFORE THE
DESK FRAME HAS BEEN
COMPLETELY ASSEMBLED!
C) x2
B) x1
D) x1 F) x4
G) x4
E)
D) x1
x Variable qty

3
8. ASSEMBLY INSTRUCTIONS
– shown assembly for right turned frame
1b
2
F) x2
1a
F) x2
2.
Pre-mounted screws
1. a) connect item 2to item 1b
b) t screws Fand tighten
c) t screws Gand tighten
a) connect item 2to item 1a
b) t screws Fand tighten
c) t screws Gand tighten
d) tighten the pre-mounted screws (x4)
G) x2
G) x2

4
1c
5
3
4
F) x2
G) x2
x Variable qty
8
6
7
E) x2
B) x1
D) x1
D) x1
E)
C) x2
Left side
4.
Right side
Mounting the electronic parts and table top
a) see the sketch on page 5 to mount item 67and Bin a suitable place
b) with the frame in the upright position t and tighten wood screws Eto secure the table top,
t from underneath, the table top must be tted with the frame fully down, like it comes out the box
c) if the assembled desk has to be moved a few cm's into its nal place
you will need minimum 3 people to lift it holding the frame and to place it back down squarely
3. 3 2
4
543
1c
Mounting Part 3: mount to the left side or the right side according to your top
a) connect item to item
b) t screws and nut F, Mand J
c) connect item to
d) t screws Fand G
e) connect item and
f) t screws F and G
F) x4
M) x2
J) x2
G) x2

5
1a 6
76
Wiring
a) connect item to item
b) connect item to item
5.

6
6.
7.
SKRUERNE MÅ IKKE SPÆNDES FOR HÅRDT,
IDET DET KAN SKADE BETJENINGEN AF
BORDET
DO NOT OVER TIGHTEN THE SCREWS
SINCE THIS MAY HARM THE FUNCTION
OF THE CONTROL
ZIEHEN SIE DIE SCHRAUBEN NICHT ZU
FEST AN DA DIES DIE FUNKTION BEEIN-
TRÄCHTIGEN KANN DER STEUERUNG

7

8