Contender C52400 User manual

C52400 ASSEMBLY INSTRUCTIONS
For assistance, call: Customer Service
18002478465
Parts:
Hardware:
(20) Hex
screws (1) Allen wrench
Set of Sides Divider
Shelf
Top
(2) Backs
Bottom
Seat
(4) Double
Hooks w/
hardware

Step 3: Slide in Divider from back side.
(2) Hex screws and Allen wrench used in
this step. Divider attaches to Top only.
Back groove in Divider aligns with back
groove in Top. Shelf and Seat sit flush
with front edge of back groove.(2) Hex
screws and Allen wrench used in this
step.
Step 2: Attach Top, Seat, and Shelf to Left Side
piece. Align back groove in Top with back groove in
Left Side. This will act as guiding system for Back in
later step. Attach each component to Left Side using
(2) Hex screws and Allen wrench. (6) Hex screws
used in this step.
For assistance, call: Customer Service 18002478465
Top
Shelf
Seat
Step 1: Using predrilled holes in Divider and
Sides, attach Hooks to Divider and Sides
using supplied hardware and screwdriver not
included. (8) gold screws used total.

For assistance, call: Customer Service 18002478465
Step 5: Attach Bottom. Grooves in Bottom
fit over Backs and Divider. (4) Hex screws
and Allen wrench used in this step.
Step 6: Set unit upright, resting edges
of Sides on floor. Tighten all screws
snugly. DO NOT OVERTIGHTEN.
DO NOT DRILL. Assembly is now
complete.
Step 4: Slide in all Backs. No hardware required in this
step. Backs will sit in grooves of Divider , Top, and Left
Side. Loosening of Seat and Shelf may be needed to slide
backs along grooving in Left Side and Divider.
Step 5: Attach second Side piece
using (8) supplied Hex screws and
Allen wrench. Grooves in Right
Side overlap previously assembled
components.