Contender Baltic Birch Neat-N-Trim C50860 User manual

ASSEMBLY INSTR CTIONS
(2) Side Piece Top Piece Bottom Piece
(2) Back Piece
(2) Skirt
(32) Hex Screws Allen Wrench
Parts:
Center Shelf Piece
Top Shelf Piece
Center Divider - 5/8” Thick
Short Divider
(2) Long Divider - 3/8” Thick
(8) Double Hooks (16) Small Screws
Tools Needed:
Phillips Head Screw Driver
(Not Included)
Step 3: Insert edge f Bottom
Piece int m rtise f Side
Piece. Make sure back
gr ves are aligned. Insert hex
screws int each f pre-drilled
h les in Side Piece and each
f the Skirt. Tighten d wn
halfway.
Step 2: Align Skirt with pre-drilled
h les n Bottom Piece. Insert hex
screws int pre-drilled h les in Bottom
Piece. Tighten d wn. Repeat f r re-
maining Skirt Piece.
Step 1: Attach h ks t Side
Pieces, b th sides f the
Center Divider and b th
sides f the Long Dividers
by using phillips head screw-
driver t screw small screws
int pre-drilled h les bef re
assembling unit. Make sure
h ks are p inted upwards
t ward the t p f the panels
as seen in illustrati n.
Step 4: Insert edge f Center
Shelf int m rtise f Side
Piece. Insert hex screws int
each f pre-drilled h les in
Side Piece. Tighten d wn
halfway. Repeat f r Top Shelf
Piece. N te: Top Shelf d es
n t receive hex screws.
Step 5: Insert edge f Center
Divider int m rtise f Side
Piece, Top Shelf, and Center
Shelf. Make sure back
gr ves are aligned.Insert hex
screws int each f pre-drilled
h les in Bottom Piece.
Tighten d wn halfway.
Step 6: Insert edge f
Long Divider int m rtise
f Side Piece, Top Shelf,
and Center Shelf. Insert
hex screws int each f
pre-drilled h les in Bottom
Piece. Tighten d wn
halfway.
Not ce - KEEP BACK GROOVES ALIGNED - Do Not Dr ll!

ASSEMBLY INSTR CTIONS
Step 7: Insert edge f
Short Divider int m rtise
f Side Piece, and Center
Shelf. Repeat f r remain-
ing Short Dividers.
Step 8: Insert edge f Back Piece int
m rtise f Side Piece, and Center
Shelf until edge rests firmly in the
back gr ve f Bottom Piece.Repeat
f r remaining Back Piece.
Step 9: Insert edge f Top Piece int
remaining m rtise f the Side Piece.
aligning back gr ves. Insert edge f
each divider int the c rresp nding
m rtise n Top Piece. Insert hex
screws int pre-drilled h les f Top
Piece and tighten d wn halfway.
Step 10: Fit remaining Side Piece ver
edge f the assembled pieces, inserting
edges int m rtises f Side Piece.
Make sure that back panels fit int back
gr ves f Side Piece. Insert hex
screws int pre-drilled h les n Side
Piece and tighten d wn halfway.
Step 11: Finish tightening all hex
screws. DO NOT OVER TIGHTEN.
Stand unit upright s that it is resting n
Bottom Piece and the edge f the Side
Pieces. Assembly is c mplete.