Trim Line®3-Way Vanity - 0109
TOOL CHECK LIST:
You will need:
1. Phillips Screwdriver
2. Tape Measure
3. Hammer
4. Pencil
5. 3/8!Drill Motor and 3/16!and 1/8!Drill Bits
6. Miter Box and Hacksaw
7. Square
8. Four 1!Screws and Screw Anchors
(For ceramic tile floors only. See Floor Check List #5.)
9. Adhesive (For ceramic tile floors only. See Floor
Check List #5.)
FLOOR CHECK LIST
1. Do you have carpet?
It is highly recommended that if you have carpet
and do not have a cut-out in the carpet already,
you should cut the carpet in order to install the
Bottom Track (#3). We do not recommend
installing the Bottom Track (#3) directly on top
of carpet.
2. Do you have a concrete, wood floor or
ceramic tile floor?
A. If it is a concrete floor, go to 3…
B. If it is a wood floor, go to 4…
C. If it is a ceramic tile floor, go to 5…
3. If you have a concrete floor you will: Use
Concrete Nails (#9) to attach Wood Strip (#4) to
floor or follow Floor Check List #5 (ceramic tile
floor).
4. If you have a wood floor you will: Use 5 Penny
Nails (#10) to attach Wood Strip (#4) to wood
floor.
5. If you have a ceramic tile floor you will: Drill holes
with a 3/16!Masonry Drill Bit. Insert Screw Anchors
and attach Wood Strip (#4) to floor with Screws. Or,
you may glue the Wood Strip (#4) down with panel
Adhesive.
Note: Drill Bit, Screws, Screw Anchors and Adhesive
are not supplied.
3
Congratulations on purchasing your new CW®Wardrobe
Doors. Now that you have opened the package, we want
you to verify that you have all the necessary hardware
supplied with your doors.
PARTS CHECK LIST:
NO. QTY DESCRIPTION
(#1) 3 Mirrored Glass Panels
(#2) 1Top C h a nn e l w it h F e lt
(#3) 1 Bottom Track
(#4) 1 Wood Strip (Located inside of track)
(#5) 6 #8 x 1-1/2!PH SMS Screws
(#6) 8 #8 x 1/2!Truss Screws
(#8) 4 Pivot Block Clamp
Assembly with
#10-32 x 7/16!Machine Screw
(#9) 4 Concrete Nail
(#10) 4 5 Penny Nail
(#14) 2 Bottom Threaded Pivot Pin
(#15) 2 Mirror Handles Bi-Fold
(#16) 2 Mirror Handles Slider
(in bag, attached to back of the panels)
(#17) 2Magnets
2 Magnet Catches
8 Screws #6 x 1/2!Pan HD
2 Screws #6 x 1/2!Flat HD
(#18) 2 Plastic Bumpers
(#19) 2 Pivot Pin Top with Spring
(#24) 1 Allan Wrench
If you find any parts that are damaged or missing, refer to
the parts list and the IPB Drawing and contact Contractors
Wardrobe®ʼs Customer Service Department at
(661) 257-1177.