Converters.TV 231 User manual

Multisystem TV Tuner
- ID# 231
Operation Manual

Introduction
This unit is a multisystem tuner that receives terrestrial and cable TV
broadcasting systems of all PAL and SECAM countries.
Features
• eceive terrestrial and cable TV broadcasting systems of all PAL and
SECAM countries.
• Full channels on TV/ CATV systems.
• Operates in 12V DC car voltage. Ideal for car video application.
• Two video outputs.
• Auto programming and channel memory.
• PLL frequency synthesizer and auto fine-tune ensures best receiving picture.
• emote out connector allows you to place the I sensor to anywhere you
want it to be, whether in a car, a boat or in your home.
Operating Functions
and
Controls
Front Panel
1. RF In- This is the F Input port. Connect the port to your Antenna or
Cable TV.
2. DC In- DC 12V In. This is the DC Input port.
3. ACC- If +ACC is used: When the +ACC wire is connected to the power,
TV tuner is switched On. If +ACC is not used: Press and release the power
button of remote control, this will have the same effect as the +ACC
function (Turn On the tuner).

Rear Panel
1. Remote Out- emote control infrared receive sensor.
2. Audio Out- This is the Audio Output port. Connect the port to your
audio device using a CA Jack.
3. Video Out 1- This is the Composite Video Output port 1. Connect the
port to your device using a CA Jack.
4. Video Out 2- This is the Composite Video Output port 2. Connect the
port to your device using a CA Jack.
Remote Control
1. Po er- This button is used to switch between power On and standby.
2. Display- This button is used to display the channel status.
3. Air/CATV- This button is used to switch between terrestrial TV
Systems and Cable TV channel systems.
4. Input- Press the button to control DC-out 12V.
5. Auto scan- This button allows you ton scan the available channels and
memorize them automatically.
6. Return- This button allows you to return to the previously selected
channel.
7. Channel ▲▼ - This is the channel select button. You may select the
channel through the up and down arrows.
8. Fine tune ▲▼ - “Fine Tuning” select up or down.
9. Select ▲▼ - This button allows you to select the aerial/cable system of
your
country.
10. 0~9- This button allows you to directly select the channel.
11. Sleep- This button allows you to set a predetermined time for the unit
to automatically turn off.
12. Mute- This button allows you to mute the sound output.
13. CH Reset- This button allows you to return to default.
14. Menu- Press this button to show all PAL and SECAM TV systems.
15. Exit- This button allows you to exit the selected menu.

Connection and
Installation
The adaptor power unit should not be plugged into a wall outlet until all
connections are complete.
- Connect the Video Output port (Number 3/4 on rear panel) and the Audio
Output port (Number 2 on the rear panel) to your TV.
- Connect your antenna or cable TV to the F Input port (Number 1 on the
front panel).
Once all connections are complete please connect the power supply provided
to the power socket.
Specifications
Inputs - F In
- DC In- 12V
- ACC
- Ground
Outputs - emote Out
- Audio out- 350mV rms 47kohm CA Jack
- Video Out 2- 1Vp-p 75ohm CA Jack
- Video Out 1- 1Vp-p 75ohm CA Jack