Cooke & Lewis CLLED60-BK User manual

Cooker hood
CLLED60-BK / CLLED70-BK / CLLED90-BK-Version:01
GB IE Cooker hood - Barcode: 5052931536917 / 5052931536924 / 5052931536931
WARNING: Read the instructions before using the appliance.

[01] x 1
[04] x 2 [05] x 1
[02] x 1 [03] x 1
[06] x 1 [07] x 1
Cooker hood

1 : 1 [12] x 4
(3.9x18)
[13] x 6
(3.9 x 32mm)
[08] x 4
[10] x 1
[09] x 4
[11] x 6
[14] x 4
(3.4 x 10mm)
Cooker Hood

4
GB IE Cooker Hood
Let's
get started...
Getting started... 05
Before you start 06
Safety
10
In more detail... 12
Product functions
Operation
Care and maintenance
Troubleshooting
Recycling and disposal
Technical and legal information
Guarantee
CE Declaration of conformity
13
13
14
17
18
19
21
23
Appendix
20
Installation
ErP Information of the bulb provided
Information for EU66
24
32
33

5
Cooker Hood
Getting
Started...
Getting started...
GB IE
Before you start
06
Safety
10

6
GB
IE
Safety
These instructions are for your safety. Please
read through them thoroughly prior to
installation and retain them for future reference.
•All installation work must be carried
electrician.
•This appliance must be installed correctly
following the manufacturer’s instructions.
This appliance complies with all current European
safetylegislation, however, the Manufacturer must
emphasisethat this compliance does notprevent
the surfaces of the appliance fromheating up
during use and remaining hot during its operation.
Accessibleparts may become hot during use.
Young children should be kept away. Care should
be taken to avoid touching the appliance
The Manufacturer highly recommends that this
appliance be kept out of the reach of babies and
small children.
This appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge if they have been
given supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involed. Children shall not play with the
appliance. Cleaning and user maintenance shall
not be made by childrenunless they are older
than 8 and supervised.
Getting started...

We also recommend that great care be taken
device in accordance with these instructions may
7
GB
IE
Safety
Keep the appliance and its cordout of reach of
childrenless than 8 years.
Means for disconnection must be incorporated
rules. An all-pole disconnection switch having a
contact separation of at least 3 mm in all poles
should be connected in fixed wiring.
Regularly check the power plug and power cord
for damage.If the supply cord is damaged,
it must be replaced by the manufacturer,its
order to avoid a dangerorinjury.
Do not allow the electric cables to touch the
hot parts of the appliance.
Make sure that the power cord is not caught
under or in the appliance and avoid damage to
the power cable.
Do not install the appliance outdoors in a
damp place or in an area which may be prone
to water leaks such as under or near a sink
unit. In the event of a water leak allow the
machine to dry naturally.
Warning: Failure to install the screws or fixing
Please dispose of the packing material
carefully.
to the appliance.
result in electrical hazards
Getting started...

during use and cleaning. Read the cleaning
8
GB
IE Safety
and maintenance sections for this appliance
carefully.
A steam cleaner is not to be used.
The appliance is not intended to be operated
by means of external timer or separated
remote-control system.
The appliance is for domestic use only.
Warning: Consult local regulations regarding
fumes outlets. Do not connect the hood to
that room ventilation is appropriate with the
local authorities. Make sure the maximum air
room does not exceed 4 Pa (0.04 mbar). The
room must have adequate ventilation if an
extractor hood is used simultaneously with
appliances that run on gas or other fuels. The
used for exhausting fumes from appliances
burning gas or other fuels. Regulations
regarding air extraction must be complied with.
Warning: Before connecting the hood: switch
off the electricity supply and check that the
supplied voltage and frequency coincide with
that indicated on the appliance nameplate.
Warning: The hood may stop working during
an electrostatic discharge (e.g. lightning). This
involves no risk of damage. Switch off the
Getting started...

9
GB
IE
Safety
electricity supply to the hood and reconnect
after one minute.
regularly and closely watch and regulate pans
containing hot oil.
Do not use the hood if it shows signs of
damage or imperfection. Contact customer
services.
Flambe cooking must not be carried out
underneath this appliance.
When installing the appliance, make sure
that the following distances between the top
of cooker or hob and the lowest part of the
cooker hood must be observed:
> Gas hobs: 750mm.
> Electric hobs: 650mm.
The Manufacturer declines all liability for
personal or material damage as a result of
misuse or incorrect installation of this appliance.
Warning
cleaning is not carried out in accordance with
the instructions.
Regarding the information pertaining to
installation, thanks to refer to the below
paragraph of the manual.
Regarding the information for replacing the bulb,
please see section "Care and maintenance"
Getting started...

Before you start
Things to check before you start
To avoid the risks that are always present when you use an
electrical appliance it is important that this cooker hood is
installed correctly and that you read the safety instructions
carefully to avoid misuse and hazards. We recommend that
you keep this instruction booklet for future reference and
pass it on to any future owners. After unpacking the cooker
hood please check that it is not damaged. If in doubt, do
not use the appliance but contact Customer Services on
044 800 1128 (UK), 01 4475261 (Ireland) and 01 56 48
02 60 (France)..
Check the package and make sure you have all of the parts
listed.
Decide on the appropriate location for your product.
This product contains glass. Care must be taken when
tting or handling to prevent personal injury or damage to
the product.
Your product
1. Cooker hood
10
Getting started...
GB IE
Cooker Hood

Before you start
Tools required
Ø6mm
CARBFILT4 (UK & IE)
OR CARBFILT4CL (FR)
SELF ADHESIVE
ALUMINIUM TAPE
Recirculation
Extraction
CARBON FILTER ORDERING HOTLINE
044 800 1128 (UK) 01 4475261 (IE)
Ø125mm or Ø150mm Ø125mm or Ø150mm
Alumnium
11
Getting started...
GB IE
Cooker Hood

12
Cooker Hood
In more detail...
In more
detail...
GB IE
Product functions 13
Operation 13
Care and maintenance 14
Troubleshooting 17
Recycling and disposal 18
Technical and legal information 19
Guarantee 21
CE Declaration of conformity 23

Product functions
This appliance extracts the air of the kitchen to remove the odours
and keep an optimum level of the air quality inside the room, it
also allows you to illuminate the cooking area.
Operation
• Switch on the appliance at the switched fused connection unit.
The appliance is ready for operation functions.
Five-button panel
Extractor fan operating control pilot light.
Lighting on and off.
Extractor fan off.
Extractor fan speed - button: speed 1
Extractor fan speed - button: speed 2
Extractor fan speed - button: speed 3
To obtain the best results from your cooker hood it is
recommended that you leave it switched on for 15 minutes after
you have nished cooking.
Product Functions
Operation
13
In more detail...
GB IE
Cooker Hood
Cooker Hood

Care and maintenance
Care and maintenance
Warning: always switch off the electricity supply before carrying
out maintenance work on the hood. In the event of a fault, contact
customer services.
Bulb replacement
The Bulb may be hot, leave it 10 minutes before replacement.
Turn to replace the Bulb.
10’
DOUBLE POLE SWITCHED
FUSED SPUR OUTLET
USE A 3AMP FUSE
FUSE ON
14
In more detail...
GB IE
Cooker Hood

Care and maintenance
2 X ACTIVE CHARCOAL FILTER (NOT SUPPLIED).
MODEL NUMBER CARBFILT4 (UK & IE) OR CARBFILT4CL (FR).
CLICK
15
In more detail...
GB IE
Cooker Hood

Exterior cleaning: use non-corrosive, liquid detergent and avoid
the use of abrasive cleaning products.
improve the cleaning process.
Important:
the hood is used for more than 2 hours a day. Always use genuine
Care and maintenance
FUSE
OFF
Warning
Always switch off the electricity supply before
performing maintenance work. In the event of a fault,
contact customer services.
3 MONTH
1 MONTH
MAX. 65˚C
16
In more detail...
GB IE Cooker Hood

Troubleshooting
Troubleshooting
17
In more detail...
GB IE
Cooker Hood
Fault Cause Solution
Excessive
vibration.
The appliance is not
installed properly on the
brackets.
Take down the appliance and
The fan blade is
damaged.
Switch off the appliance. Repair
service personnel only.
tightly.
Light on, but
motor does not
work.
The fan blade is jammed.
The motor is damaged.
Both light and
motor do not
work.
Light bulb blown. Replace with a bulb with correct
rating.
Power connection loose. Check power supply.
Suction
performance
reduced.
Speed may be too low. Select a higher speed.
Distance between the
cooker hood and the hob
is too great.
Readjust the distance to:
Gas hobs: 750mm
Electric hobs: 650mm
dirty.
Care and
maintenance section.
Top vent might be
obstructed.
Clear any obstruction.
Optional vent kit might be
twisted. the manufacturers instructions.
Works normally
but cooking
smells linger.
in recirculation mode or
grease.
Care and
maintenance section.

Recycling and disposal
Recycling and disposal
Environmental protection
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check with
your Local Authority or retailer for recycling advice.
The symbol on the product or its packaging indicates
that this product cannot be treated as normal
household waste. This product must be handed over to
an electric and electronic equipment collection point for
recycling.
On ensuring that this product is disposed of correctly, you will help
to avoid possible negative consequences for the environment
and public health, which could occur if this product is not handled
correctly. To receive more detailed information about recycling this
product, contact your local government, domestic waste disposal
services or the outlet where the product was bought.
18
In more detail...
GB IE Cooker Hood
Supply voltage 220-240V~, 50Hz
Power consumption - Fan 95W
Power consumption - Luminary GU10 2 x 4W Max
Power consumption - Total 111W
Protection class II
Light bulb 2X3W LED(supplied)
Decorative Lights 8W

19
In more detail...
GB IE
Cooker Hood Technical and legal information
Wiring
All installation work must be carried out by a competent
Before connecting the mains supply ensure that the mains
voltage corresponds to the voltage on the rating plate.
WARNING: THIS APPLIANCE MUST NOT BE EARTHED.
Mains Supply could be connected to the Mains Voltage by Direct Connection
USE A 3AMP FUSE
DOUBLE POLE SWITCHED
FUSED SPUR OUTLET
FUSE ON
EUR UK
OFF
N (Blue) N (Blue)
L (Brown) L (Brown)
Direct Connection
If the appliance is being connected directly to the mains an omnipolar circuit-
breaker must be installed with a minimum opening of 3mm between contacts.
The installer must ensure that the correct electrical connection has been made
and that it complies with wiring diagram.
The cable must not be bent or compressed.
Regularly check the power plug and power cord for damage. If the supply cord is
damaged, it must be replaced by a special cord or assembly available from the
manufacturer or its service agent.

Technical and legal information
20
In more detail...
GB IE Cooker Hood
Technical and legal information
The Manufacturer declines all liability for damage caused to persons and objects
due to incorrect or improper installation of the appliance.
Electrical Requirements
Any permanent electrical installation must comply with the latest I.E.E. regulations
electrician or contractor who is on the roll of the National Inspection Council
for Electrical Installation Contracting (NICEIC) should undertake the electrical
installation.
Electrical Connection
Before connecting the mains supply ensure that the mains voltage corresponds to
the voltage on the rating plate inside the appliance.
WARNING: THIS APPLIANCE MUST NOT BE EARTHED
The appliance is supplied with a 2-core mains cable and must be connected to
the electricity supply via a double pole switch having a 3mm minimum contact gap
on each connector.
For UK only
A Switched Fused Connection Unit to BS 1363 Part 4 is recommended.
The fuse must be rated at 3 Amps.
The wires in the mains lead are coloured in accordance with the following code:
Brown = L - Live
Blue = N - Neutral
The connection point must be placed in a position adjacent to the appliance so as
to be readily accessible for an engineer in the event of a breakdown.