Cooper Lighting INVUE IMI-567 User manual

These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible
contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please
contact your nearest representative.
TOP VISOR INSTALLATION
1. Partially screw the (6) provided 8-32 SET SCREWS
into the threaded holes in the top and sides of the
fixture door.
2. Place the TOP VISOR into the groove in the fixture
door.
3. Make sure the SET SCREWS and slots in the TOP
VISOR are aligned then securely tighten the set
screws.
4. Check to make sure the SET SCREWS pass
through the slots in the TOP VISOR and provide a
secure attachment.
Customer First Center • 1121 Hwy 74 South • Peachtree City, GA 30269 IMI-567 AVU033141
VFM TOP VISOR and
FOUR SIDED SHIELD
Sheet 1 of 1
9/15/03 IMI-567
INSTALLATION INSTRUCTIONS
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
General: Upon receipt of fixture thoroughly inspect for any
freight damage, which should be brought to the attention of
the delivery carrier. Compare the catalog description listed
on the packing slip with the fixture label on the housing to
assure you have received the correct merchandise.
Safety: This fixture must be wired in accordance with
the national electrical code and applicable local codes
and ordinance. Proper grounding is required to insure
personal safety. Carefully observe grounding procedure
under installation section. All work should be done by a
qualified electrician.
TM
WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing
or servicing.
FOUR SIDED SHIELD INSTALLATION
1. Partially screw the (8) provided 8-32 SET SCREWS
into the threaded holes in the top and sides of the
fixture door.
2. Place the SHIELDS into the groove in the fixture
door.
3. Make sure the SET SCREWS and slots in the
SHIELDS are aligned then securely tighten the set
screws.
4. Check to make sure the SET SCREWS pass
through the slots in the SHIELDS and provide a
secure attachment.