Coopers 9379 User manual

Pie Maker 9379 Instructions
Ple se re d c refully before use
nd ret in for future reference.

PARTS
Handle & lock
Housing
Top hot plate
Bottom hot plate (pie mould)
Base housing
Green indicator light
Red indicator light
Pie Maker 9379
BEFORE USE
• Remove all the packing.
• Clean the surfaces with a damp cloth.
• Connect the Mains Plug into a suitable wall outlet socket and switch on.
• It is recommended that the first pies cooked with this appliance are discarded
as some residual deposits may be present from the manufacturing process.
There may some light smoking from the plates during this process, this is
normal.
• Lightly season the plates with vegetable oil before first use and wipe away
any excess.
• The inner plates become very hot during use. Take care when handling this
product especially when removing food after cooking.
• The unit must first heat up before you start making pies. This takes
approximately 4-5minutes with the unit lid closed. The red indicator will go
out when the unit has reached the required temperature.
Reversable
pie cutter

USE
• Place your Pie Maker on a stable, flat, level heat-resistant surface.
• Close the cover and plug into the mains socket. The red light will turn on
indicating that the appliance is powered and preheating.
• In approximately 5-10 minutes the green light will illuminate when the
appliance is pre-heated and ready for use. The green light will cycle on and off
during the cooking process indicting that the correct temperature is being
maintained as the thermostat automatically maintains the correct temperature.
Always keep the cover closed when preheating or in-between uses.
• Pies will take approx. 8-15 minutes to cook depending on the type of filling.
Always check pies are fully cooked before serving.
COOKING
C kes & Muffins
1. If making cakes and muffins
fill the pie mould
approximately 2/3rds full
(see fig.1) with mixture
unless the recipe states
otherwise. Close the cover
and press the locking latch
in until it clicks.
2. Set a timer for the specified time as indicated in your recipe.
3. When the cooking time is complete unplug the Pie Maker from the mains
socket. Pull the locking latch up from the bottom and carefully lift the lid. If
you need additional browning simply close the lid and set a timer to the
desired additional time.
4. Carefully remove the cake or muffin from the mould by using a spatula. Do not
use metal utensils as they will damage the non-stick surface.
Pies & T rts
1. If making pies and tarts, use the reversible pie cutter (Fig. 2) to make the
moulds. The larger side is for the pie base, and the smaller for the pie lid. If you
are using a pre-made pie crust dough you can get two bases from one crust.
Position pie cutter as close to the edge of the pie crust dough as possible and
press firmly down.
2. For the second base, cut the pie edges from the side and re-position in the
centre (Fig.3). The pie cutter creates slits in the dough for the bases (Fig. 4)
that allow you to overlap the dough for a better fit.
3. Unless the recipe states otherwise we recommend using puff pastry dough for
the lids, and standard pie crust dough for the bottom (pie tarts do not have
tops, when finished filling the base mould close the cover and start the
cooking process).
4. Open the Pie Maker and place the large base dough over the pie mould
(Fig.5).
5. Add your fillings (unless recipe states otherwise) up to 3/4of the depth of the
pie mould. (see figure 6). The weight of the fillings will cause the dough to
drop down into the mould; you can also use the bottom of a ladle or rounded
spoon to gently press the dough into the mould being careful not to tear the
dough. Press the dough down gently over the edges. Note: Some fillings such
as meats will need to be pre-cooked before adding. Do not add raw
ingredients.
6. W rning - The pre-heated cooking surfaces are hot. Never touch the cooking
surface directly with your fingers.
7. If your recipe has a top (Fig. 7),
place the moulded dough top
over the filled mould and close
the cover. Press the locking latch
in until it clicks and locks into
position.
8. Set a timer for the specified time
as indicated in your recipe.
9. When the cooking time is complete unplug the pie maker from the wall outlet.
Pull the locking latch up from the bottom and carefully lift the lid. If you need
additional browning simply close the lid and set the timer to the desired time.
10. Carefully remove the pie from the mould by using a spatula. You can also use
a bamboo skewer to slide down the side of the pie. Lift one end of the pie up
and slide the spatula underneath to remove the pie from the housing. Be
careful as the pie, its filling, and appliance are hot. Do not use metal utensils
to avoid damaging the non-stick surface.
Reversable
pie cutter
Fig. 1
Fig. 2
Fig. 4Fig. 3
Fig. 5 Fig. 6
Fig. 7

DISPOSAL
• Dispose of all paper, cartons and plastic in accordance with your local recycling
regulations. At the end of the product’s lifespan please dispose of it at an
authorised household waste recycling centre.
TECHNICAL INFORMATION
Rated Voltage AC220-240V 50HZ
Rated Power 1000W
Protection Class I
EC DECLARATION OF CONFORMITY
We The Enterprise Department Ltd.
Of 11 Bridge Street, Bishop’s Stortford, Hertfordshire, UK. CM23 2 U
in accordance with the following Directive(s):
Electromagnetic Compatibility 2004/108/EC
EN 55014-1: 2006+A1:2009+A2:2011
EN 55014-2: 1997+A1:2001+A2:2008
EN 61000-3-2: 2006+A1:2009+A2:2009
EN 61000-3-3: 2008
Low Voltage Directive 2006/95/EC
EN 62233:2008
EN60331:2002+A11:2004+A1:2004+A2+A12:2006
+A13:2008+A14:2010+A15:2011
EN 60335-2-9:2003+A1:2004+A2:2006+A12:2007
+A13:2010+AC:2011+
EK1-AG2:2012-01
hereby declare that:
Pie Maker
Model number: 9379 (SM-1014PM)
I hereby declare that the equipment named above has been designed to comply
with the relevant sections of the above referenced specifications. The unit
complies with all applicable Essential Requirements of the Directives.
Mr. Stuart Fowler
Imports Director
December 2012
WARNING
• For indoor, domestic use only.
• Place the Pie Maker on a flat, even, stable heat-resistant surface.
• Always locate your appliance away from the edge of a worktop.
• Do not let the mains cable hang over the edge of a worktop.
• Keep the appliance and the cable away from heat sources, direct sunlight,
moisture and sharp edges.
• Ensure the mains cable does not touch the outer casing as this can become hot
during use.
• Do not carry the Pie Maker by the power cord. Always pull the plug from the
socket, do not pull the cord.
• Keep the power cable away from heat sources and hot surfaces, including the
Pie Maker itself.
• Check the appliance and power cord for damaged before use. Do not use if the
appliance or power cord is damaged.
• No user serviceable parts.
• Do not immerse the cord, plug and or appliance in water or any other liquid.
• Extreme caution must be observed when moving an appliance with hot
contents. It is recommended to remove the pie without moving the Pie Maker
and allowing the pie maker to cool fully before moving.
• Do not use the Pie Maker with wet or moist hands.
• This unit will become hot during use. Take care to not touch the surfaces until it
has cooled down fully.
• Do not use this unit for any use other than its intended use.
• This product must be connected to an earthed supply.
• Do not use this unit near to, or below combustible material such as curtains.
• Where ventilation is provided on the underside of the unit do not obstruct this
with cloth or other materials as this will cause overheating.
• Allow sufficient ventilation space around the unit for heat and steam to
escape.
• Do not move the unit whilst it is operating.
• Do not leave the unit unattended whilst connected to the mains power supply.
• Keep away from children. Do not allow children to use the unit.
• This unit is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning the use of
the unit by a person responsible for their safety.
• This unit is not intended to be operated by means of an external timer or
separate remote control system.
CLEANING
• Always switch off and unplug the unit from the socket when not in use and
always allow to cool before cleaning or storing.
• Clean with a paper towel whilst the unit is still warm but not hot.
• The remains of the mix are best removed with a soft brush.
• Never use sharp or pointed objects or hard brushes.
• Do not immerse in water.