Touch Panel is configured via built-in web interface. It has dual Ethernet
network interfaces which use DHCP by default.
Connect Touch Panel to a network that has DHCP server via home or building
network.
Go to Settings in Touch Panel user interface and then get IP address of Touch
Panel.
Enter IP address to web-browser, then enter username and password
Default username: webAdmin Default password: wa1234
If you need support in further steps, visit www.core.com.tr and check CoreOS
Programming Manual.
1. Power Supply: 12 VDC
2. USB Mini: Reserved for debugging
3. USB-C: Reserved for programming
4. ETH0: Building network. Connection to intercom
clients, smart devices and internet access in building.
5. ETH1: Home network. Connection to smart devices,
intercom clients and internet access at home
6. Outputs (Q1-Q4): 4 x 8A Latching Relay
7. Inputs (I1-I5): Digital Inputs
8. KNX: Connection to KNX-TP bus line
9. RS-485: Connection to RS-485
connected devices
10. RS-232: Connection to R-232
connected device
Note: Core Touch S is able to connect to two different
IP networks at the same time. This feature allows
to isolate home and building networks in buildings.
REAR VIEW
INSTALLATION
wall
box
wall
box
side front
1. Insert Core Touch S 10” Inwall Box
Wall Box should be
aligned vertically
In-Wall box sold seperately.
Inwall box dimensions:
127mm x 217mm x 60mm
CONFIGURATION
208.00
264.00
1
3
2
4
5
8
10
9
6
7
